Polaroid 111523 manual Reassembly

Repair Manual Macro 5 SLR Camera

2.Reassembly

a.Connect the trigger cables (J31) to its applicable trigger PC boards.

Note: Make sure each cable is properly dressed and secured by the white cable clamps attached to the side of the left/right cover.

b.Using both hands, gently install the left/right cover assembly (includes the front cover) onto the camera back making sure that it properly aligns with each bottom screw hole and that it properly fits around the turret assembly.

c.Connect the battery cable to its left cover tie post.

d.Using a torx driver, install and tighten the screw that secures the bottom of the right cover to the camera back (Figure 5-2).

e.Using a torx driver, install and tighten the screw that secures the bottom of the left cover to the camera back (Figure 5-2).

f.Install the film door button adapter. It should snap into place.

g.Using a torx driver, install and tighten the three (3) screws that secure the right hand grip to the right cover.

Note: Be careful not to pinch the battery cable between the right hand grip and its cover.

h.Using a torx driver, install and tighten the three (3) screws that secures the left hand grip to the left cover.

Note: Be careful not to pinch the S1/S2 cable between the left hand grip and its cover.

i.Using a torx driver, install and tighten the single screw that secures the left/right covers to the top of the turret assembly.

j.Using a torx driver, install and tighten the single screw that secures the turret knob to the top of the turret assembly.

k.Install a new adhesive vinyl pad (Part Number 1B6614A) to the bottom of the camera back.

l.Connect the camera’s power source: Install the battery holder, snap battery cable clip onto hjolder connection, slide battery cover closed.

42