Polaroid 111523 manual Electrostatic Discharge Warning, Inspection and Cleaning

Page 38

Repair Manual	Macro 5 SLR Camera

Electrostatic Discharge Warning

The camera circuitry can easily be damaged by static discharges. Always use an anti-static mat and a wrist-strap when servicing the camera's PC Boards.

Inspection and Cleaning

Whenever disassembling the camera for parts replacement, always inspect the following assemblies for dust and debris (reagent developer).

Note: If necessary, clean the replaced parts with a water dampened tissue or soft clean rag to assure that dust and debris (reagent developer)

do not interfere with camera performance.

•Front Cover Assembly

•Camera Back Rollers

•Turret Assembly

•Cone Assembly

•Shutter Assembly

•Viewfinder Assembly

Disassembly/Assembly of Camera

This section of the Service Manual describes disassembly/reassembly procedures. Before performing any of these procedures, always make sure that the camera is turned off and the film pack is removed.

CAUTION

To prevent any chance of electric shock, the camera should be opened only by a qualified service person, and only after it has been disconnected from its power source (film pack battery); make sure the strobe capacitors are fully discharged (dumped). Also, take care not to damage (bend or distort) any of the camera components during disassembly and reassembly.

38

Image 38

Contents Rev replaces September Technical Services Burlington Road Bedford MA TEL FAXRepair Manual Contents Other Documents Required for Service Purpose of this Manual Organization of this ManualCamera Description AdjustmentsParts Replacement Theory of OperationSchematics S1/S2 PC BoardCamera Description Important Safety Instructions General Macro 5 SLR CameraFeatures CameraMacro 5 SLR Features Electronic Flash Units Macro 5 SLR Camera Features Cont’dTwo Built-In Dual-Light RangefinderBattery Compartment Right/Left Hand GripsRed Shutter S1 Button Control Panel Control PanelLow Battery Control Panel FeaturesPower Button Reset ButtonMagnification Status Lights Control Panel Features Cont’dLighten/Darken Controls RS232 ReceptacleDate/Time Display Specifications Dimensions Specifications Cont’d MagnificationWeight AccessoriesTheory of Operation Filter Kit Camera SetupOperation Macro 5 SLR Camera Camera Setup Picture Taking Macro 5 SLR Camera Picture Taking Adjustments Ranging Aim Lights Adjustment Camera Test FixtureRange Light Adjustment Range Light Adjustments Grid Adjustment Grid PositionGrid Adjustments Troubleshooting Diagnostics Module Parts Replacement Macro 5 SLR Camera Required Tools and Equipment Electrostatic Discharge Warning Inspection and CleaningDisassembly/Assembly of Camera Left/Right Cover Includes Front Cover Removal -1, 5-2 and 5-2aCamera Disassembly Left/Right Bottom Screw Location Reassembly Front Cover Removal FigureReassembly Rear Cover Removal Figures 5-2Reassembly Bottom Cover Bottom coverReassembly Strobe PC Board Strobe PC BoardReassembly Trigger PC Boards Trigger PC Boards S1/S2 PC Board S1/S2 PC BoardReassembly Control Panel Reassembly Logic PC Board 10 Logic PC Board Camera Back 11 Camera Back Macro 5 SLR Camera Encoder Plate and PC Board Removal -12 and 5-12a12a Encoder PC Board Reassembly Turret Assembly 13 Turret AssemblyReassembly Shutter Solenoid Assembly 14 Shutter Solenoid AssemblyReassembly Bulb Aim Light Bracket Assembly 15 Aim Light Cable AssemblyReassembly Date Code Module 16 Date Code ModuleReassembly Firmware Logic PC Board 17 Firmware CPU Schematics S1/S2 PC Board Encoder PC Board Trigger PC Board Strobe PC Board 1 Strobe PC Board 2 Logic PC Board 1 Logic PC Board 2 Communication PC Board