Setting Up the Printer
Loading the Ribbon
To load the ribbon into the printer:
1.If you are replacing a ribbon, remove the used ribbon from the printer.
NOTE: Images remain on the ribbon after printing. If you need to maintain confidentiality, dispose of the used ribbon appropriately.
2.Insert your fingers into the holes in the plastic on the end of the ribbon.
Remove the plastic cover from the ribbon.
IMPORTANT: Do not remove the label/wrapper from the ribbon at this time.
Label/wrapper
Supply spool
3. Push the right end of the supply spool into the front spool holder on the right.
Bar code
4.Place the bar code end of the supply spool into the front spool holder on the left.
IMPORTANT: Make sure to line up the notches on the supply spool with the lugs on the spool holder.