Kodak 9810 manual Installing the Print Catcher

Page 11

Setting Up the Printer

Label/wrapper

5.Remove the label/wrapper from the ribbon.

Take-up spool

6.Push the right side of the take-up spool into the rear spool holder on the right.

7.Place the left side of the take-up spool into the rear spool holder on the

left.

8. Rotate the take-up spool until it locks into place.

9.If there is any slack in the ribbon, remove it by turning the take-up spool.

IMPORTANT: Slack in the ribbon can cause a paper jam when making prints.

Installing the Print Catcher

The print catcher collects finished prints as they exit the printer.

• Set the print catcher into the printer as shown.

Print catcher

1-7

Image 11

Contents Digital Photo Printer Kodak Professional4J5025 Table of Contents Using the Diagnostic Tool Recommended Air Flow Clearances Setting Up the PrinterBefore You Begin Loading the Paper Paper roll Move the lever to the locked position Install the trim tray Loading the Ribbon Installing the Print Catcher Connecting the power cable Connecting the CablesTurning On the Printer Page Printer Driver Software Click Software Installing the Printer DriverBorderless Printing Select Printing Preferences Customizing Printer PropertiesCustomizing Printing Preferences Select PropertiesColor Management using Adobe Photoshop 7.0 or Greater Creating a Custom Package Custom Image Composition PackagesExample Selecting a Custom PackageLoading the Ribbon on Resolving Printing ProblemsSmaller page size Select File Server Properties Uninstalling the Printer and Printer DriverSelect Start Printers Printers FaxesPage Calibrating the Printer Installing the Calibration SoftwareSelect Easy-Cal Begin Using the Easy Cal Calibration UtilityClick Proceed Click Select Printer Click Change Setup Following dialog box appears Calibrating the Printer Uninstalling the Calibration Software Ribbon on Resolving Calibration Error MessagesPage Understanding the Operator Panel Lights Using Setup Mode to Review Printer SettingsOperating the Printer Print SettingsChanging the quantity of test prints Working in Test Print ModePage Adjusting Print Head and Paper Cutter Registration Using the Diagnostic ToolClick Print to print a test Cutter offset Updating Firmware Click the Update Firmware tabTroubleshooting the Printer Warming Print head is too cold to print Energy Star Partner Printer SpecificationsAppendix a Important Printer Information Page Important Safety Information Appendix B Safety Regulatory InformationSafety Radio frequency interference Safety LabelsRegulatory and Safety Compliance Disposal Noise emissionPage Index Temperature