Kodak 9810 manual Noise emission, Disposal

Ad

Page 49

Safety and Regulatory Information

EN61000-4-3 Radiated rf immunity

EN61000-4-4 EFT

EN61000-4-5 Surge

EN61000-4-6 Conducted rf immunity

EN61000-4-11 Voltage dips and interruptions

•EN 61000-3-2 Harmonics

•EN 61000--3-3 Flicker

"Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment."

Noise emission	The operator-position noise emission value is 58 dB(A).*
	* Average value specified in accordance to JIS Z873.
Disposal	This product contains a small amount of lead in the solder on the circuit
	boards. Disposal of this material may be regulated due to environmental
	considerations. For disposal or recycling information, please contact your
	local authorities. In the USA, contact the Electronics Industry Alliance at
	http://www.eiae.org.
	In the European Union, this symbol indicates that when the last user wishes to
	discard this product, it must be sent to appropriate facilities for recovery and
	recycling. Contact your local Kodak representative or refer to
	www.kodak.com/go/recycle for additional information on the collection and
	recovery programs available for this product.

B-3

Image 49

Contents Digital Photo Printer Kodak Professional4J5025 Table of Contents Using the Diagnostic Tool Before You Begin Setting Up the PrinterRecommended Air Flow Clearances Loading the Paper Paper roll Move the lever to the locked position Install the trim tray Loading the Ribbon Installing the Print Catcher Connecting the power cable Connecting the CablesTurning On the Printer Page Printer Driver Software Borderless Printing Installing the Printer DriverClick Software Customizing Printing Preferences Customizing Printer PropertiesSelect Properties Select Printing PreferencesColor Management using Adobe Photoshop 7.0 or Greater Creating a Custom Package Custom Image Composition PackagesExample Selecting a Custom PackageLoading the Ribbon on Resolving Printing ProblemsSmaller page size Select Start Printers Uninstalling the Printer and Printer DriverPrinters Faxes Select File Server PropertiesPage Calibrating the Printer Installing the Calibration SoftwareSelect Easy-Cal Begin Using the Easy Cal Calibration UtilityClick Proceed Click Select Printer Click Change Setup Following dialog box appears Calibrating the Printer Uninstalling the Calibration Software Ribbon on Resolving Calibration Error MessagesPage Operating the Printer Using Setup Mode to Review Printer SettingsUnderstanding the Operator Panel Lights Print SettingsChanging the quantity of test prints Working in Test Print ModePage Adjusting Print Head and Paper Cutter Registration Using the Diagnostic ToolClick Print to print a test Cutter offset Updating Firmware Click the Update Firmware tabTroubleshooting the Printer Warming Print head is too cold to print Appendix a Important Printer Information Printer SpecificationsEnergy Star Partner Page Important Safety Information Appendix B Safety Regulatory InformationRegulatory and Safety Compliance Safety LabelsSafety Radio frequency interference Disposal Noise emissionPage Index Temperature