Kodak 9810 manual Paper roll

Page 7

Blue paper flange

Setting Up the Printer

6. Attach the paper flanges provided with the printer to each end of the

paper roll.

Lugs

Notches

Red paper flange

Label

a.	Line up the lugs on the blue paper flange with the notches on the left
	side of the paper roll.
b.	Place the blue paper flange on the left side of the paper roll.
c.	Place the red paper flange on the right side of the paper roll.

NOTE: Be sure to line up the lugs on the blue paper flange with the notches on the left side of the paper roll. If you do not attach the paper flange properly, the paper roll will not fit into the printer.

7.Gently set the paper roll into the printer according to the blue and red arrows on the label.

8.Remove the label.

1-3

Image 7

Contents Digital Photo Printer Kodak Professional4J5025 Table of Contents Using the Diagnostic Tool Before You Begin Setting Up the PrinterRecommended Air Flow Clearances Loading the Paper Paper roll Move the lever to the locked position Install the trim tray Loading the Ribbon Installing the Print Catcher Connecting the power cable Connecting the CablesTurning On the Printer Page Printer Driver Software Borderless Printing Installing the Printer DriverClick Software Select Printing Preferences Customizing Printer PropertiesCustomizing Printing Preferences Select PropertiesColor Management using Adobe Photoshop 7.0 or Greater Creating a Custom Package Custom Image Composition PackagesExample Selecting a Custom PackageLoading the Ribbon on Resolving Printing ProblemsSmaller page size Select File Server Properties Uninstalling the Printer and Printer DriverSelect Start Printers Printers FaxesPage Calibrating the Printer Installing the Calibration SoftwareSelect Easy-Cal Begin Using the Easy Cal Calibration UtilityClick Proceed Click Select Printer Click Change Setup Following dialog box appears Calibrating the Printer Uninstalling the Calibration Software Ribbon on Resolving Calibration Error MessagesPage Operating the Printer Using Setup Mode to Review Printer SettingsUnderstanding the Operator Panel Lights Print SettingsChanging the quantity of test prints Working in Test Print ModePage Adjusting Print Head and Paper Cutter Registration Using the Diagnostic ToolClick Print to print a test Cutter offset Updating Firmware Click the Update Firmware tabTroubleshooting the Printer Warming Print head is too cold to print Appendix a Important Printer Information Printer SpecificationsEnergy Star Partner Page Important Safety Information Appendix B Safety Regulatory InformationRegulatory and Safety Compliance Safety LabelsSafety Radio frequency interference Disposal Noise emissionPage Index Temperature