Kodak 9810 manual Turning On the Printer

Page 13

Setting Up the Printer

Turning On the Printer

ON

OFF

IMPORTANT: Install the printer driver software before turning on the printer. See “Printer Driver Software” on page 2-1.

Press the power switch to on ( ).

On the operator panel, the orange Power light and the green Ready light illuminate, and the Ready message appears when the printer is initialized.

1.To turn off the printer, press the power switch to off ().

CAUTION:

If you transport or ship the printer, first remove the media. Failure to do so can damage the printer.

1-9

Image 13

Contents Digital Photo Printer Kodak Professional4J5025 Table of Contents Using the Diagnostic Tool Before You Begin Setting Up the PrinterRecommended Air Flow Clearances Loading the Paper Paper roll Move the lever to the locked position Install the trim tray Loading the Ribbon Installing the Print Catcher Connecting the power cable Connecting the CablesTurning On the Printer Page Printer Driver Software Borderless Printing Installing the Printer DriverClick Software Customizing Printing Preferences Customizing Printer PropertiesSelect Properties Select Printing PreferencesColor Management using Adobe Photoshop 7.0 or Greater Creating a Custom Package Custom Image Composition PackagesExample Selecting a Custom PackageLoading the Ribbon on Resolving Printing ProblemsSmaller page size Select Start Printers Uninstalling the Printer and Printer DriverPrinters Faxes Select File Server PropertiesPage Calibrating the Printer Installing the Calibration SoftwareSelect Easy-Cal Begin Using the Easy Cal Calibration UtilityClick Proceed Click Select Printer Click Change Setup Following dialog box appears Calibrating the Printer Uninstalling the Calibration Software Ribbon on Resolving Calibration Error MessagesPage Operating the Printer Using Setup Mode to Review Printer SettingsUnderstanding the Operator Panel Lights Print SettingsChanging the quantity of test prints Working in Test Print ModePage Adjusting Print Head and Paper Cutter Registration Using the Diagnostic ToolClick Print to print a test Cutter offset Updating Firmware Click the Update Firmware tabTroubleshooting the Printer Warming Print head is too cold to print Appendix a Important Printer Information Printer SpecificationsEnergy Star Partner Page Important Safety Information Appendix B Safety Regulatory InformationRegulatory and Safety Compliance Safety LabelsSafety Radio frequency interference Disposal Noise emissionPage Index Temperature