Kodak 9810 manual Click Select Printer

Page 28

Calibrating the Printer

8.Click Next.

The following dialog box appears.

9.Confirm that the printer model listed is the printer you want to calibrate.

•If the printer you want to calibrate is listed, go to Step 13.

•If you want to calibrate a different printer than the one that is listed, continue with Step 10.

10.Click Select Printer.

The following dialog box appears.

NOTE: The appearance of this dialog box may vary, depending on your printer setup and the media file you selected.

11.From the Serial #: list, select your printer’s serial number.

NOTE: Click Blink to Identify to locate a specific printer if you have more than one printer. The Ready light on the operator panel of the printer will blink five times.

Click Update if you want to update the printer information on the dialog box.

12.Click OK to close the dialog box.

3-4

Image 28

Contents Kodak Professional Digital Photo Printer4J5025 Table of Contents Using the Diagnostic Tool Before You Begin Setting Up the PrinterRecommended Air Flow Clearances Loading the Paper Paper roll Move the lever to the locked position Install the trim tray Loading the Ribbon Installing the Print Catcher Connecting the Cables Connecting the power cableTurning On the Printer Page Printer Driver Software Borderless Printing Installing the Printer DriverClick Software Customizing Printer Properties Customizing Printing PreferencesSelect Properties Select Printing PreferencesColor Management using Adobe Photoshop 7.0 or Greater Custom Image Composition Packages Creating a Custom PackageSelecting a Custom Package ExampleResolving Printing Problems Loading the Ribbon onSmaller page size Uninstalling the Printer and Printer Driver Select Start PrintersPrinters Faxes Select File Server PropertiesPage Installing the Calibration Software Calibrating the PrinterUsing the Easy Cal Calibration Utility Select Easy-Cal BeginClick Proceed Click Select Printer Click Change Setup Following dialog box appears Calibrating the Printer Uninstalling the Calibration Software Resolving Calibration Error Messages Ribbon onPage Operating the Printer Using Setup Mode to Review Printer SettingsUnderstanding the Operator Panel Lights Settings PrintWorking in Test Print Mode Changing the quantity of test printsPage Using the Diagnostic Tool Adjusting Print Head and Paper Cutter RegistrationClick Print to print a test Cutter offset Click the Update Firmware tab Updating FirmwareTroubleshooting the Printer Warming Print head is too cold to print Appendix a Important Printer Information Printer SpecificationsEnergy Star Partner Page Appendix B Safety Regulatory Information Important Safety InformationRegulatory and Safety Compliance Safety LabelsSafety Radio frequency interference Noise emission DisposalPage Index Temperature