Weight
930 g (2.05 lbs)
DYNAMICS PROCESSOR
Gate and Expander
Threshold: ±72 to ±1 dB, 0.5 dB resolution
Attack: 1.0 to 200 ms
Decay: 0.05 to 1 second
Gate Hold Time: 0 to 0.5 seconds
AGC Leveler
Threshold: ±72 to ±1 dB, 0.5 dB resolution
Attack: 0.2 to 3 seconds
Decay: 0.5 to 5 seconds
Hinge: Threshold to ±1 dB, 0.5 dB resolution
Compressor and Limiter
Threshold: ±72 to ±1 dB, 0.5 dB resolution
Attack: 1.0 to 200 ms
Decay: 0.05 to 1 second
Knee: Hard or Soft selectable
No Overshoot Peak Limiter
Propagation delay: 1 ms
Threshold: ±72 to ±1 dB, 0.5 dB resolution
Attack: 0 ms
Decay: 100 ms
PARAMETRIC EQUALIZER
Parametric Filter Frequency Bands
Up to 9 bands, variable frequency, variable Q
Boost/Cut Range
+6 dB to ±18 dB per band
Q Range
High and Low Shelf/Cut Filters Shelf, +6 to ±18 dB per filter Cut, ±12 dB per octave nominal
DELAY
Up to 1.3 seconds, 21 microsecond resolution
FURNISHED ACCESSORIES
Power Cable (DP11EQ ) . . . . . . . . . . . . . . . . 95A8389
Power Cable (DP11EQE) . . . . . . . . . . . . . . . . 95A8247
Single Mount Rack Bracket . . . . . . . . . . . . . . 53A8484
Dual Mount Rack Bracket . . . . . . . . . . . . . . . 53B8484
Straddle Bars . . . . . . . . . . . . . . . . . . . . . . . . . . 53A8443
SERVICE STATEMENT
For additional service or parts information, please
contact Shure's Service department at
CERTIFICATIONS
DP11EQ : UL LISTED and cUL LISTED to UL 813 and CSA C22.2 No. 1. Authorized under Verification provision of FCC Part 15 as a Class B Digital Device. DP11EQ E: Conforms to European Union Directives, eligible to bear CE marking. Meets European Union Low Voltage Requirements: VDE
INFORMATION TO USER
Changes or modifications not expressly approved by Shure Incorporated could void your authority to
operate this equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
SReorient or relocate the receiving antenna.
SIncrease the separation between the equipment and receiver.
SConnect the equipment into an outlet on a circuit different from that to which the receiver is connected.
SConsult the dealer or an experienced radio/TV technician for help.
English ±27