Shure manual Appendix B. Rack Mounting the DP11EQ, Single Unit, Dual-Mounted Units

Page 29

APPENDIX B. RACK MOUNTING THE DP11EQ

The DP11EQ comes in a 1/2-rack chassis specially designed for sturdiness. The sagging and bending found in most 1/2-rack designs is eliminated Ð the brackets and straddle bars are designed to ensure that the units will be installed securely.

WARNING: Do not torque the screws too tightly, or the chassis may be dam- aged.

Single Unit

DATA

1.Align the supplied rack-mount brackets over the holes.

2.Fasten with the 8 supplied screws.

Dual-Mounted Units

DATA

DATA

1.Align two units side by side so that the front panels both face the same direction.

2.Place the supplied straddle bars in the recesses on the top and bottom of the units, so that they overlap both. Fasten with the supplied screws.

NOTE: Be sure to use both straddle bars when installing dual units.

3.Position the rackmount brackets over the holes in the side of the unit. Fasten with the supplied screws.

Mounting in an Equipment Rack

DATA

SINGLE MOUNT

DATA

DATA

DUAL MOUNT

1.Insert the unit(s) into a 19-inch equipment rack.

2.Fasten the unit(s) to the rack using all four of the supplied screws.

English ±28

Image 29

Contents DP11EQ Table of Contents Introduction Hardware FeaturesSoftware Features Overview DP11EQ HardwareFront Panel BackShure Link Device ID DIP SwitchesSubgroup Insert Audio ConnectionsMain Amplifier Input Insert Software Installation Connecting the DP11EQ to a Computer via the RS-232 COM PortDP11EQ Software IntroductionShure Program Group Configuring the Computer Serial PortAccessing the Connected DP11EQs Overview Processor Select Buttons Main ControlsDynamics Processor Dynamics Parameters Expander Dynamics ProcessesGate AGC Leveler Limiter CompressorEditing Dynamics Processes SnapshotsParametric Equalizer High- and Low-Frequency Shelf/Cut Filters Setting and Adjusting Parametric FiltersParametric Equalizer Edit Boxes and Controls Cutting, Copying, and Pasting Parametric Filters Response GraphMeter Calibration IN/OUT Meters and Output ControlDelay for Solving Phase Cancellation Problems DelayDelay for Solving Remote Speaker Alignment Setting Delay by Distance Reversing the Output Signal PolaritySetting Delay by Time Shure Link Connections Shure Link NetworksShure Link Options Shure Link Device MenuScenes MaintenanceTo Save Settings to Disk SettingsTo Recall Settings from Disk Customizing Graph ColorsPrinting DP11EQ Settings Appendix A. SpecificationsLocking Out the Front Panel Exiting the DP11EQ ApplicationDelay Single Unit Appendix B. Rack Mounting the DP11EQDual-Mounted Units Mounting in an Equipment RackAudio Cables Appendix C. Connectors and CablesAudio Connectors In. to 1/4 -in. Unbalanced In. to 1/4 -in. BalancedIn. Balanced to 1/4 -in. Unbalanced XLR male to 1/4 -in. BalancedRCA to 1/4 -in. Unbalanced XLR female to 1/4 -in. BalancedXLR female to 1/4 -in. Unbalanced Computer Interface Ð 9-Pin to 9-Pin RS-232 Cable Digital Connectors and CablesComputer Interface Ð 9-Pin to 25-Pin RS-232 Cable Shure Link Cable Ð 5-Pin DIN Cable MIDI-compatible cableGeneral Controls Appendix D. Keyboard ControlsParametric Equalizer Controls IN/OUT Meters and Output Slider Controls