JVC GR-DVJ70 specifications Date/Time Settings, Select Operation Mode, Access Recording Menu

12EN GETTINGSTARTED (Cont.)

Date/Time Settings

If you set the date and time beforehand, the data will automatically be recorded separately from the video signal.

Even if the date and time do not appear during recording, you can display them on the screen or remove them from the screen at any time during playback.

VIEWFINDER VIEWFINDER

T

W

WIDE MODE	O FF
ZOOM	2 0X
D I S	OFF	ON SCREEN	OFF
GA I N UP	AGC	D I SPLAY	OFF

TO	FADER / W IPE	MENU	DATE/T I ME	25. 12. 97
TO	P. AE / EFFECT	MENU		17: 30
TO	DATE / TIME MENU

TO SYSTEM MENU
END	I TEM	ZOOM	SW .		I TEM	ZOOM	SW .
	SET	SET	BUTTON	END	SET	SET	BUTTON

RECORDING MENU	DATE/TIME MENU
MENU BUTTON	ZOOM LEVER
	SET BUTTON
		MANUAL
	AUTO
		FOCUS
		EXP.
POWER DIAL	SET	WB
		PRO

1 SELECT OPERATION MODE

Set the Power Dial to “REC” and the Select Dial to “MANUAL”.

2 ACCESS RECORDING MENU

Press MENU. The Recording Menu appears in the viewfinder.

3 ACCESS DATE/TIME MENU Place the pointer next to “TO DATE/TIME MENU” by sliding the Zoom Lever. Slide toward “+” to move up and toward “–” to move down. Press SET and the Date/Time Menu appears in the viewfinder.

4 INPUT DATE AND TIME

Place the pointer next to “DATE/TIME” by sliding the Zoom Lever. Press SET and “Day” begins blinking.

Using the Zoom Lever (slide toward “+” to increase and toward “–” to decrease), input the day. Press SET. Repeat the procedure to input the month, year, hour and minute. Press SET when the pointer is next to “END” to exit.

NOTE:

If you don’t exit the Date/Time Menu, the clock display will not move but the camcorder’s internal clock continues to operate. Once you close the menu, the date and time in the viewfinder begin operation from the current date and time, with no delay or loss.