NOTES:
●If you connect the camcorder’s DC cord to the adapter during battery charging, power is supplied to the camcorder and charging stops.
●When using the AC Power Adapter/Charger, be sure to use the supplied power cord only.
●When charging the Battery Pack for the first time or after a long storage period, the Charge Indicator may not light. In this case, remove the Battery Pack from the AC Power Adapter/Charger, then try charging again.
●Since the AC Power Adapter/Charger processes electricity internally, it becomes warm during use. Be sure to use it only in
●Be sure to securely connect the power cord to the AC Power Adapter/Charger.
●Before connecting to an AC outlet, connect the power cord to the AC Power Adapter/Charger. If you plug into an AC outlet first and the power cord’s terminal comes in contact with a metal surface or object, there is the possibility of a short circuit or fire.
** Charging Environment
Perform charging where the temperature is between 10° and 30°C.
Recording Time
BATT. PACK | RECORDING TIME |
approx. 30 min. | |
approx. 50 min. | |
|
|
Recording time under the following conditions:
•The temperature is approximately 20°C However, . . .
•If the temperature is below 10°C, or
•If Zoom or RECORD/STANDBY are engaged repeatedly, continuous shooting capability is reduced significantly. Before extended use, it is recommended that you prepare enough battery packs to cover 3 times the planned shooting time.
EN 9
Installing The Battery Pack
The battery pack does not charge while in the camcorder. Before installation, make sure the battery pack has been charged fully.
BATTERY COVER
BATTERY
1 OPEN BATTERY COVER
Move the cover in the direction of the arrow.
2 INSERT BATTERY
Remove its protective cap and insert the + – end of the battery first.
3 CLOSE BATTERY COVER
NOTE:
To remove a discharged battery pack, simply open the cover and slide the battery pack out.