JVC GR-DVJ70 specifications Recording From The Middle Of a Tape, Start Search, Engage Still Mode

EN 27

PLAY

OFF

REC

5S

PLAY

OFF

REC

5S

RECORDING

START/STOP BUTTON

STOP PLAY		REW	FF	PLAY
	/PAUSE	RE SHOOT	CAN.	/PAUSE

Recording From The Middle Of A Tape

When removing a tape on which you were recording, or when you resume recording on a tape after playing back the recording previously made (without taking the tape out between recordings), perform this procedure.

1 SELECT MODE

Set the Power Dial to “PLAY”.

2 START SEARCH

Press PLAY, then press REW or FF. Watch in the viewfinder for the spot where you want to begin recording.

3 ENGAGE STILL MODE

Once you find the spot at which you want to start recording, press PLAY/PAUSE to engage the Still mode.

4 START RECORDING

Set the Power Dial to “REC” and press

RECORDING START/STOP.

NOTES:

●Starting at 00:00:00 (MIN:SEC:FRAME), the camcorder records a time reference signal from the beginning of the tape. See page 47 for information about displaying Time Codes.

The video recording may not start from exactly 00:00:00.

●The Time Code cannot be reset.

●If you start recording from the end of the previous recording leaving no blank space, there may be situations where a clean transition is not possible.

●Whenever you start recording in a blank portion, the Time Code counts from 00:00:00. That means the camcorder may record the same Time Codes as a

previously-recorded segment. Random Assemble Editing (☞ pg. 52) may not function properly when using a tape with duplicated codes. To prevent this, start recording from the end of the previous recording leaving no blank space. Note that such a blank space may be also left between scenes when a tape is removed and re-inserted.

●Even if you record over the blank space between two already-recorded segments, the old Time Codes remain after the newly-recorded portion, and thus

duplicated codes will still exist. Random Assemble Editing (☞ pg. 52) may not function properly in the case.