
EN 13
Loading/Unloading A Cassette
If you have already installed a fully charged battery, you can open the door without external power.
CASSETTE HOLDER
OPEN/EJECT SWITCH
CASSETTE COVER
Erase protection switch
PUSH HERE
Once you open the cassette cover, a blank portion is recorded on the tape even if you close it before the cassette holder comes out. See page 26 for information about recording from the middle of a tape.
Make sure the window side is facing out.
1 OPEN CASSETTE DOOR
Turn on the power, then slide the OPEN/EJECT switch in the direction of the arrow. The cassette cover releases. Open the cover in the direction of the arrow until it locks. The holder opens automatically.
•Do not touch internal components.
2 INSERT/REMOVE TAPE
Insert or remove a tape and press “PUSH HERE” to close the cassette holder.
•Once the cassette holder is closed, it recedes automatically. Wait until it recedes completely before closing the cassette cover.
•When the battery's charge is low, you may not be able to close the cover. Do not apply force. Replace the battery with a fully charged one before continuing.
TAPE | RECORDING TIME |
DVM 30 | Approx. 30 min. |
|
|
DVM 60 | Approx. 60 min. |
|
|
NOTES:
●It takes a few seconds for the cassette holder to open. Do not apply force.
●If you wait a few seconds and the cassette holder doesn’t open, close the cassette cover and try again.
●Be careful not to get your fingers caught in the holder when it’s closing. If this happens, the holder will open automatically after a few seconds.
●When the camcorder is suddenly moved from a cold place to a warm environment, wait a short time before opening the cover.
** To protect valuable recordings . . .
..... slide the erase protection switch on the back of
the tape in the direction of “SAVE”. This prevents this tape from being recorded over. If you decide later that you do want to record on this tape, slide the switch back to “REC” before loading the tape.