JVC KY-F58 System Application,
To start a flash light with a foot switch, Hd/Vbs

3. CONNECTIONS (Cont’d)

SYSTEM APPLICATION

								KY-F58	CAMERA
								Camera head	VIDEO
									COLOR
				VD				Microscope adapter
					HD/VBS
								HZ-M161/M162/M163
(Front panel)
AC- INPUT SEE INSTRUCTION MANUAL		RS-232C		EXT REF		OUTPUT
				VD	HD/VBS	Y/C
					VIDEO
		LENS		EXT TRIGGER				Flash light
		REMOTE	FLASH	WEN	FREEZE	RGB/COMPONENT
To 120V AC	LENS	FLASH		WEN	FREEZE VIDEO
	REMOTE
							VD
							HD/VBS
							RGB
							WEN
						VIDEO IN
Lens remote control				Foot switch, etc.			Monitor	Image processing unit

To start a flash light with a foot switch

•	Connect an external trigger such as a foot switch to the		Note:
	FREEZE connector.	Before starting the connection, please thoroughly read the
•	Connect a flash light to the FLASH connector.	Technical Information on page 26 and following.

•Set the FREEZE MENU to “FLASH”.

To output an image from the KY-F58 under the tim- ing of the image processing unit

•Connect an external sync signal of the image processing unit to the VD and HD/VBS connector of this unit.

•Connect the image output connector to the image input connector of the image processing unit.

To output an image to the image processing unit under the timing of the KY-F58

•Connect the WEN (Write Enable) connector of the KY-F58 to the image processing unit.

•Connect the image output connector to the image input connector of the image processing unit.

11