2. PARTS NAMES AND FUNCTIONS (Cont’d)
CAMERA CONTROL [Rear side] (Cont’d)
29[FLASH] Flash signal output connector (BNC)
When the FREEZE item is set to the FLASH, a flash signal is output from this connector according to FREEZE input. It is recommended to be used when the unit is operated with a flash.
Refer to the “SYSTEM APPLICATION” on page 11. Refer to the “FLASH Function” on page 28.
30[WEN] write enable signal output connector (BNC) It outputs the write enable signal.
Connect to the image processing unit, etc. .
Refer to the “SLOW SHUT FUNCTION” on page 27. Refer to the “Random Trigger Function” on page 28
31[FREEZE] freeze input connector
This is a trigger input signal connector from an external source.
It connects with an external trigger unit such as foot switch, etc. A negative electrode signal with a pulse width of 20∝ sec. to 50∝ sec. and a pulse interval of 40 msec. or more should be
input for the trigger signal.
Refer to the “FREEZE SCREEN” on page 21.
CAMERA HEAD
| 5 |
1 | 6 |
|
2
3 |
4
POWER
TO CCU | LENS |
7
1Lens mount
This is where the lens is to be mounted. It fits to the C mount lens.
Refer to “MOUNTING THE LENS (T14X5.5MD) TO THE CAMERA HEAD” on page 9.
2Camera mounting bracket (Accessory)
The camera mounting bracket is not installed on the cam- era when it is shipped from the factory.
Install it on the top or bottom of the camera according to your requirements using the two provided camera mount- ing bracket fixing screws 4 .
Refer to the “HOW TO MOUNT THE CAMERA HEAD” on page 10.
31/4 inch screw hole for camera mounting to a tripod These are for mounting the camera to a fixed or rotating table, etc.
4The provided fixing screws for camera mounting bracket (two of M2.6 x 6 mm)
Caution:
Make sure to use the provided screws.
Do not use a screw longer than 6 mm because it may cause a malfunction.
5[POWER] power supply LED
When the power is supplied to a camera head, this LED lights.
6[TO CCU] CCU connector
This is to connect a camera control unit (CCU) with a pro- vided cable (5 m).
Refer to the “CONNECTING THE CAMERA HEAD AND CCU” on page 10.
1
52
10 | 6 | View from the rear of the camera head |
15 | 11 | |
|
For the signal names, refer to the “ 14
1916 [TO CAMERA]” on page 6.
20
7[LENS] lens connector
This is to connect the lens to be used.
Refer to the “MOUNTING THE OPTIONAL LENS (T14 X 5.5MD) TO THE CAMERA HEAD” on page 9.
| 7 |
|
|
|
|
|
8 | 6 |
|
|
|
|
|
|
|
| Pin No. | Signal | Pin No. | Signal |
5 |
| 3 | 1 | LENS SEL | 5 | SERVO SEL |
|
|
|
|
| ||
| 2 | GND | 6 | ZOOM CTL | ||
|
|
| ||||
|
|
|
|
|
|
|
|
|
| 3 | IRIS CTL/IRIS Y | 7 | FOCUS CTL |
|
|
|
|
|
|
|
2 | 4 |
| 4 | 15V | 8 | IRIS CTL/IRIS Y |
| 1 |
|
|
|
|
|
View from the rear of the camera head
8