JVC KY-F58 Connections, Basic Systems, Mounting the Optional Lens T14 X 5.5MD to the Camera Head

3. CONNECTIONS

BASIC SYSTEMS

Mounting the optional lens (T14 X 5.5MD) to the camera head (See page 9.)

Lens	male	Monitor
(T14 x 5.5 MD)	Camera head	female
	To CCU
	KY-F58
	COLOR VIDEO CAMERA
	To LENS

How to mount the camera head (See page 10.)

Connecting the camera

[LENS REMOTE]head and CCU (See page 10.)

Provided cable
(5m)	OUTPUT

Recommended Remote Controllers

• TCR-201F (CANON) for positioning control

Note:

When using an extension cable, the screen flickers slightly during the focusing operation..

• RMD-10 (FUJINON) for speed control

male

To CAMERA

	CAMERA CONTROL UNIT KY-F58			LENS REMOTE terminal
PULL OPENMENU	FILES		FREEZE
1	2	3	4	on the rear panel
SELECT			MEMORY
			POWER

TO CAMERA WHITE PAINT VIDEO LEVEL

SET	FULL AUTO	LEVEL
		ON

RB

OFF

PAINT

CCU (Camera Control Unit) LENS remote control

female

• The LENS remote controller should be connected to the REMOTE terminal on the rear panel of the CCU or to LENS REMOTE on the lens.

MOUNTING THE OPTIONAL LENS (T14 X 5.5MD) TO THE CAMERA HEAD

Camera head 3.

Screws

Mount fastening ring

Lens

2.

1. Remove the lens mount cap for the camera.

Be careful no dust gets into the mounting hole when you remove it.

2. Attach the screw of the camera head mount section to that of the lens mount section. Turn the mount fastening ring slowly clockwise and fix the lens to the camera head by screwing it firmly.

To change the attitude angle of the lens rotating direction.

1Turn the mount fastening ring counter-clockwise from the lens side.

2Turn the lens slowly to adjust the attitude angle, and fas- ten it again firmly with the mount fastening ring.

Note:

The KY-F58 is not equipped with a lens.		4mm or less	3. Plug in the lens cable to the LENS connector of the camera
When a lens other than the T14x5.5MD
of the 3-CCD C-mount lens is used, it may			head and fasten it firmly.
cause the KY-F58 to malfunction. When	Lens		For more details, refer to the Instructions for the Lens.
such a lens is used, the lens' height
should not be more than 4 mm above the
lens mount surface.

9