JVC JY-HD10 manual 32 EN, Initialising a Memory Card, To Reset The Number Of Prints

FORMAT

ERASE ALL

EX I ST I NG DATA?

EXECUTE

RETURN

DPOF

SHEETS

0 5

32 EN D.S.C. PLAYBACK (cont.)

To Print By Selecting Still Images And Number Of Prints

1Perform steps 1 – 6 in “To Print All Still Images (One Print For Each)” ( pg. 31).

2Rotate the MENU Wheel

Initialising A Memory Card

You can initialise a memory card any time. After initialising, all files and data stored in the memory card, including those which have been protected, are cleared.

to select “CURRENT”, and press it. The DPOF screen

DPOF

1 Set the Playback Mode Switch to “MEMORY”.
2	P

appears.SHEETS

3 Press 3 or 5 to	0 0
	RETURN
select the desired file.

4 Rotate the MENU Wheel to select the number

indication (00), and press it.

	Set the Power Switch to “	” while pressing
3	down the Lock Button located on the switch.
	Open the LCD monitor fully, or pull out the
4	viewfinder fully.
	Press the MENU Wheel in.

5 Select the number of prints

The Menu Screen appears. PROTECT

DELETE

DPOF

MENU

by rotating the MENU Wheel towards “R” to increase number, or towards “T” to decrease the number, and press it.

●Repeat steps 3 through 5

for the desired number of prints.

●The number of prints can be set up to 15.

●To correct the number of prints, select the image again and change the number.

6Rotate the MENU Wheel

to select “RETURN”, and	DPOF
press it. The “SAVE?”
appears.	SAVE?
● If you did not change
	EXECUTE
	CANCEL
any settings in step 3
through 5, the Menu
Screen reappears.

7Rotate the MENU Wheel to select “EXECUTE” to save the setting you have just made, and press it. ● To cancel selection, select “CANCEL”.

To Reset The Number Of Prints

1Perform steps 1 – 6 in “To Print All Still Images (One Print For Each)” ( pg. 31).

2Rotate the MENU Wheel to select “RESET”, and press it. The DPOF screen appears.

3Rotate the MENU Wheel to select “EXECUTE”, and press it. The normal playback screen appears.

●To cancel selection, select “RETURN”.

●The number of prints is reset to 0 for all still images.

CAUTION:

While performing the above, never disconnect power, as this may cause the memory card to be corrupted.

NO . RESET

FORMAT

D I SPLAY

BR I GHT

END

5 Rotate the MENU Wheel to select “FORMAT”, and press it. The FORMAT screen appears.

6 Rotate the MENU Wheel to select “EXECUTE”, and press it. The memory card is initialised.

●When initialisation is finished, “NO IMAGES STORED” appears.

●To cancel initialisation, select “RETURN”.

CAUTION:

Do not perform any other operation (such as turning off the camcorder) during initialisation. Also, be sure to use the provided AC Power Adapter/Charger, as the memory card may be corrupted if the battery becomes exhausted during initialisation.