JVC JY-HD10 manual 72 EN

72 EN			TROUBLESHOOTING (cont.)
35.	Coloured bright spots appear	35.	•The LCD monitor and the	35.
	all over the LCD monitor or the		viewfinder are made with
	viewfinder.		high-precision technology.
			However, black spots or
			bright spots of light (red,
			green or blue) may appear		—
			constantly on the LCD
			monitor or the viewfinder.
			These spots are not recorded
			on the tape. This is not due to
			any defect of the unit.
			(Effective dots: more than
			99.99 %)
36.	The indicators and the image	36.	•This may occur when the	36.
	colour on the LCD monitor are		surface or the edge of the		—
	not clear.		LCD monitor is pressed.
37.	The cassette will not load	37.	•The battery’s charge is low.	37. •Install a fully charged battery.
	properly.				( pg. 10, 11)
38.	The memory card cannot be	38.	—	38.	•Push in the memory card a
	removed from the camcorder.				few more times. ( pg. 17)
39.	Picture does not appear on the	39.	•The viewfinder is pulled out	39.	•Push the viewfinder back in
	LCD monitor.		and “PRIORITY” is set to		or set “PRIORITY” to “LCD”
			“FINDER”.		or “BOTH”.
			•The LCD monitor’s brightness		( pg. 12, 33, 36)
			setting is too dark.		•Adjust the brightness of the
					LCD monitor. ( pg. 13)
					•If the monitor is tilted
					upward 180 degrees, open
					the monitor fully. ( pg. 12)
40.	Images on the LCD monitor	40.	•The speaker volume is too	40.	•Turn the speaker volume
	are jittery.		great.		down. ( pg. 22)
41.	The LCD monitor, the	41.		41.	•Wipe them gently with soft
	viewfinder and the lens have				cloth. Wiping strongly can
	become dirty (ex. fingerprints).		—		cause damage. ( pg. 79) To
					clean the viewfinder, please
					consult your nearest JVC
					dealer.
42.	Time code does not appear.	42.	•“TIME CODE” is set to	42.	•Set “TIME CODE” to “ON”.
			“OFF”.		( pg. 33, 37, 40)
43.	An error indication (E01, E02	43.	•A malfunction of some kind	43.	•  pg. 75.
	or E06) appears.		has occurred. In this case the
			camcorder’s functions
			become unusable.
44.	An error indication (E03 or	44.	•A malfunction of some kind	44.	•  pg. 75.
	E04) appears.		has occurred. In this case the
			camcorder’s functions
			become unusable.
45.	The remote control does not	45.	•“REMOTE” is set to “OFF”.	45.	•Set “REMOTE” to “ON”.
	work.		•The remote control does not		( pg. 33, 36)
			point at the remote sensor.		•Point at the remote sensor.
			•The remote control batteries		( pg. 56)
			are exhausted.		•Replace the batteries with
					fresh ones. ( pg. 56)