JVC JY-HD10 manual Equipped With An i.LINK, Dubbing To Or From a Video Unit

		EN 53
Dubbing To Or From A Video Unit		To use this camcorder as a player
		1 Make sure all units are turned off.
Equipped With An i.LINK
		2 Connect this camcorder to a video unit equipped
Connector (Digital Dubbing)		with an i.LINK input connector using an i.LINK
		cable as shown in the illustration.
Using an i.LINK cable (optional), it is possible to dub		3 Set this camcorder’s Playback Mode Switch to
		“VIDEO”.
recorded scenes in DV format from the camcorder
		4 Set this camcorder’s Power Switch to “P”
onto another video unit equipped with i.LINK
connector. Since a digital signal is sent, there is little		while pressing down the Lock Button located on
if any image or sound deterioration.		the switch.
Scenes recorded in SD or HD mode can be dubbed		5 Set “i.LINK OUT” to “SW”. ( pg. 33, 37)
only to a D-VHS VCR with HS mode or another		● If, in future, the connected video unit
same model of this unit.		automatically detects the DV and MPEG2
		formats, set “i.LINK OUT” to “AUTO”. In this
		case, proceed to step 7.
		6 Set the i.LINK Output Select Switch on this
		camcorder to “DV” to output scenes recorded in
		DV mode, or “MPEG2” to output scenes
		recorded in HD or SD mode.
i.LINK Output Select		7 Turn on the video unit’s power.
	Connector Cover*	8 Insert the source cassette in this camcorder.
Switch
		9 Insert the recording cassette in the video unit.
	To i.LINK IN/OUT	10 Press 4·9 on this camcorder to start playback
		of the source cassette.
		11 At the point you want to start dubbing, engage
		the video unit’s Record mode.
	i.LINK cable	12 To pause dubbing, engage the video unit’s
	(optional)	Record-Pause mode and press 4·9 on this
		camcorder.
		13 Repeat steps 10 – 12 for additional editing.
		Stop the video unit and camcorder.
To i.LINK IN/OUT		NOTES:
		● If a blank portion or disturbed image is played
		back on the player during dubbing, unusual
		images may be dubbed or the dubbing may stop.
		● If a scene which has been paused during
		recording is dubbed to other devices, playback
		may stop at the point.
Video unit equipped with		● If “Wipe Or Fader Effects” ( pg. 48), “Special
		Effects” ( pg. 49), “Playback Zoom (DV only)”
i.LINK connector
		( pg. 57) or “Time Code” ( pg. 37) is set, only
* When connecting the cable, open the cover.		the original playback image is output from the
		i.LINK IN/OUT connector.
NOTES:

●It is recommended to use the AC Power Adapter/ Charger as the power supply instead of the battery pack. ( pg. 11)

●When using an i.LINK cable, be sure to use the optional JVC VC-VDV204U i.LINK cable.

●If the remote control is used when both the player and recorder are JVC video units, both units will perform the same operation. To prevent this from happening, press the buttons on both units.

ADVANCED FEATURES

CONTINUED ON NEXT PAGE