JVC GR-DV2000 How To Attach Core Filter, Release the stoppers on both ends of the Core Filter

EN5

How To Attach Core Filter

Attach the provided Core Filter to an optional external microphone. Core Filter reduces interference.

1

Stopper

Release the stoppers on both ends of the Core Filter.

2

3 cm

wind once

Run the cable through the Core Filter, leaving approx. 3 cm of cable between the cable plug and the Core Filter. Wind the cable around the outside of the Core Filter as shown in the illustration.

•Wind the cable so that it is not slack.

NOTE:

Take care not to damage the cable.

3

Close the Core Filter until it clicks shut.

When connecting cables, attach the end with the Core Filter to the camcorder.

AUTOMATIC DEMONSTRATION

Automatic Demonstration takes place when “DEMO MODE” is set to “ON” (factory-preset).

 Available when the Power Switch is set to “ ” or “ ” and no cassette is in the camcorder.

Performing any operation during the demonstration stops the demonstration temporarily. If no operation is performed for more than 1 minute after that, the demonstration will resume.

“DEMO MODE” remains “ON” even if the camcorder power is turned off.

To cancel Automatic Demonstration:

1.Set the Power Switch to “ ” while pressing down the Lock Button located on the switch and press the MENU wheel. The Menu Screen appears.

2.Rotate the MENU wheel to select “ SYSTEM” and press it. The SYSTEM Menu appears.

3.Rotate the MENU wheel to select “DEMO MODE” and press it. The Sub Menu appears.

4.Rotate the MENU wheel to select “OFF” and press it.

5.Rotate the MENU wheel to select “1RETURN”, and press it twice. The normal screen appears.

MENU Wheel

DEMO MODE – OFF

ON

Sub Menu