58 EN
Power Switch
To DV OUT 
Core filter
DV cable (optional)
Core filter 
To DV IN 
Video unit 
equipped with DV input connector
PLAY (4)
STOP (5)
DUBBING (cont.)
Dubbing To A Video Unit Equipped With A DV Connector (Digital Dubbing)
It is also possible to copy recorded scenes from the camcorder onto another video unit equipped with a DV connector. Since a digital signal is sent, there is little if any image or sound deterioration.
[To use this camcorder as a player]
1 Make sure all units are turned off. Connect the camcorder to a video unit equipped with a DV input connector using a DV cable as shown in the illustration.
2 Set the camcorder’s Power Switch to “ 
” while pressing down the Lock Button located on the switch, turn on the video unit’s power, and insert the appropriate cassettes in the camcorder and the video unit.
3 Press 4to play back the source tape.
4 While watching the playback on the monitor, engage the DV
NOTES:
●It is recommended to use the AC Power Adapter/
Charger as the power supply instead of the battery pack ( pg. 7).
●If the remote control is used when both the player and recorder are JVC video units, both units will perform the same operation. To prevent this from happening, press the buttons on both units.
●For Digital Dubbing, this camcorder can be connected only to one device at a time.
●If a blank portion or disturbed image is played back on the player during dubbing, the dubbing may stop so that an unusual image is not dubbed.
●Even though the DV cable is connected correctly, sometimes the image may not appear in step 4. If this occurs, turn off the power and make connections again.
●If “Playback Zoom” ( pg. 63), “Playback Special Effects” ( pg. 64) or “Snapshot” is attempted during playback, only the original playback image recorded on the tape is output from the DV OUT connector.
●When using a DV cable, be sure to use the optional JVC