Power Switch
To DV IN |
|
Core filter |
|
DV cable |
|
(optional) |
|
Core filter |
|
To DV OUT | Video unit |
equipped with |
DV output connector
EN59
Dubbing From A Video Unit Equipped With A DV Connector (Digital Dubbing)
[To use this camcorder as a recorder]
NOTE:
Before the following steps, make sure that “S/AV INPUT” is set to “OFF” in the Menu Screen ( pg. 39).
1 Make sure all units are turned off. Connect the camcorder to a video unit equipped with a DV output connector using a DV cable as shown in the illustration.
2
3 Set this camcorder’s Power Switch to “ 
” while pressing down the Lock Button located on the switch. Turn on the video unit’s power and insert the appropriate cassettes in the camcorder and the video unit.
4 Press the Recording Start/Stop Button on the camcorder to engage the
“DV. IN ” appears on the screen.
5 Engage the video unit’s Play mode, then engage the Still Playback mode when you have found a spot just before the
6 Press the Recording Start/Stop Button on the
camcorder to engage the Record mode. 
rotates on the screen. Engage the video unit’s Play mode.
7 To stop dubbing, press the Recording Start/Stop
Button on the camcorder so that 
stops rotating, then engage the video unit’s Stop mode.
8 Repeat steps 5 through 7 for additional editing.
NOTES:
●It is recommended to use the AC Power Adapter/Charger as the power supply instead of the battery pack ( pg. 7).
●If the remote control is used when both the player and recorder are JVC video units, both units will perform the same operation. To prevent this from happening, press the buttons on both units.
●For Digital Dubbing, this camcorder can be connected only to one device at a time.
●If a blank portion or disturbed image is played back on the player during dubbing, the dubbing may stop so that an unusual image is not dubbed.
●Even though the DV cable is connected correctly, sometimes the image may not appear in step 5. If this occurs, turn off the power and make connections again.
●When using a DV cable, be sure it has a core filter attached. The core filter reduces interference.
●Digital Dubbing is performed in the sound mode recorded on the original tape, regardless of the current “SOUND MODE” setting ( pg. 27).
●During Digital Dubbing, no signals are output from the video or audio connectors.