JVC GR-DV2000 specifications 72 EN, Insert Editing

Press REW (2) until the Edit-In point is located, then press PAUSE (6).

72 EN	USING THE REMOTE CONTROL UNIT (cont.)
Display	Insert Editing

6w

12 : 34

Power Switch

Lock Button

Remote sensor

START/STOP

INSERT

REW PLAY

You can record a new scene into a previously recorded tape, replacing a section of the original recording with minimal picture distortion at the in and outpoints. The original audio remains unchanged.

NOTES:

●Before performing the following steps, make sure that

“TIME CODE” is set to “ON” in the Menu Screen ( pg. 39).

●Insert Editing is not possible on a tape recorded in the LP mode or on a blank portion of a tape.

●To perform Insert Editing while watching in the television, make connections (  pg. 52).

1 Play back the tape, locate the Edit-Out point and press PAUSE (6). Confirm the time code at this point ( pg. 40).

2

3 Press and hold INSERT (w) on the remote control, then press PAUSE (6). “6w” and the Time Code (min.:sec.) appear and the camcorder enters Insert- Pause mode.

4 Press START/STOP to begin editing.

•Confirm the insert at the time code you checked in step 1.

•To pause editing, press START/STOP. Press it again to resume editing.

5 To end Insert Editing, press START/STOP, then STOP (5) on the remote control. Do not press the Stop button (5) on the camcorder since this will activate backlight compensation instead.

NOTES:

● Programme AE with special effects (  pg. 34, 35) can

be used to spice up the scenes being edited during Insert

Editing.

● During Insert Editing, the date and time information

changes.

● If you perform Insert Editing onto a blank space on the

STOP

PAUSE

tape, the audio and video may be disrupted. Make sure

you only edit recorded areas.

● During Insert Editing, when the tape moves to scenes

recorded in the LP mode or a blank portion, Insert Edting

stops (  pg. 87).