JVC GR-DV2000 Corrective Action, Replace with new cassette, Clean the lens and check

Page 73

TROUBLESHOOTING

EN73

If, after following the steps in the chart below, the problem still exists, please consult your nearest JVC dealer.

The camcorder is a microcomputer-controlled device. External noise and interference (from a TV, a radio, etc.) might prevent it from functioning properly. In such cases, first disconnect its power supply unit (battery pack, AC Power Adapter/Battery Charger, etc.) and wait a few minutes; and then re-connect it and proceed as usual from the beginning.

	SYMPTOM			POSSIBLE CAUSES		CORRECTIVE ACTION
1.	No power is supplied.		1. • The power is not connected			1. • Connect the AC Power
			properly.			Adapter/Charger securely
			• The battery is dead.			( pg. 7).
			• The LCD monitor is not open			• Replace the dead battery
			fully or the viewfinder is not			with a fully charged one
			pulled out when recording.			( pg. 6, 7).
						• Open the LCD monitor fully
						or pull out the viewfinder.

2.	“SET DATE/TIME!”		2. • The built-in clock’s			2. • Connect the camcorder to
	appears.		rechargeable lithium battery			an AC outlet using the AC
			is discharged.			Power Adapter/Charger for
			• The previously set date/time			over 24 hours to charge the
			is erased.			clock’s lithium battery
						( pg. 9).

3.	Recording cannot be		3. • The tape’s erase protection			3. • Set the tape’s erase
	performed.		tab is set to “SAVE”.			protection tab to “REC”
			• The Power Switch is set to			( pg. 10).
			“	” or “OFF”.		• Set the Power Switch to
			•“TAPE END” appears.			“	” or “ ” ( pg. 12).
			• The cassette holder cover is			• Replace with new cassette
			open.			( pg. 10).
						• Close the cassette holder
						cover.

4.	There is no picture.		4. • The camcorder is not getting			4. • Turn the camcorder’s power
			power, or some other			off and on again
			malfunction exists.			( pg. 16).

5. Some functions are not			5. • The Power Switch is set to			5. • Set the Power Switch to
	available using the MENU		“	”.		“	” ( pg. 12).
	wheel.

6. The focus does not adjust			6. • Focus is set to the Manual			6. • Set Focus to the Auto mode
	automatically.		mode.			( pg. 25).
			• The recording was done in a			• Clean the lens and check
			dark place, or the contrast			the focus again ( pg. 80).
			was low.
			• The lens is dirty or covered
			with condensation.

CONTINUED ON NEXT PAGE

Image 73

Contents GR-DV2000 It is recommended that you Dear CustomerMake sure you only use cassettes with the Mini DV mark EN3Align the lens How To Attach The Lens HoodHood with Camcorder’s lens Screw it Clockwise Release the stoppers on both ends of the Core Filter How To Attach Core FilterCharging the Battery Pack PowerAbout Batteries Using AC Power Using the Battery PackTo Detach The Battery Pack Approximate recording timeViewfinder Adjustment Grip AdjustmentShoulder Strap Attachment Tripod MountingBuilt-in Clock’s Rechargeable Lithium Battery Date/Time SettingsLoading/Unloading a Cassette 10 ENEN11 Loading a Memory CardTo Unload a Memory Card Power Switch Position Manual Operation ModeShooting Mode Switch Position 12 ENEN13 Recording Mode Setting14 EN Picture Mode SettingGo to step Storage Capacity EN15Approximate number of storable images 16 EN To Adjust The Brightness Of The DisplayTo Stop Recording Journalistic Shooting EN17Interface Shooting To turn the tally lamp or beep sounds off, pgSnapshot For Video Recording Snapshot Mode SelectionBasic Shooting Snapshot 20 EN Slide the Power Zoom Lever towards TZoom Zoom OutEN21 When a blank portion is recorded on a tapeProper recording To End Progressive Mode Recording Progressive Mode RecordingEN23 Description of Progressive Scan CCDRegular shooting of moving images Dual Shooting EN Recording Advanced Features For Video And D.S.C.Feature Manual Focus Feature Auto FocusEN25 To obtain correct focusIf you have selected FADER/WIPE Program AE or W. Balance Using Menus For Detailed AdjustmentSee pg SYSTEM, Display or DSCMenu Screen Explanations EN27Video pg and Camera Mode is set to Video or PS Refer to Self-Timer pgVideo pg and Camera Mode is set to PS-VIDEO Refer to 5-Second Recording pgEN29 Self-Timer EN31 Second RecordingInstead of pressing the Recording Start/Stop Button FADE/WIPE Selection Fade/Wipe EffectsPicture Wipe or Dissolve Selection Fader And Wipe Menu EN33Menu Effect Press PROG.AE again so that the effect indicator Disappears To Deactivate The Selected ModeProgramme AE With Special Effects Sports Variable Shutter Speed 1/250 1/4000*1 EN35STROBE*2 Slow Slow Shutter*2Iris Lock Exposure ControlManual White Balance Operation White Balance AdjustmentEN37 To Return To Automatic White BalanceAvailable only with the remote control pg To Control The Speaker Volume38 EN Playback Advanced Features For Video Playback Sound 40 ENDisplay Blank Search To cancel Blank Search midwayEN41 Press Blank SearchNormal Playback 42 ENAuto Playback Press Memory PlayIndex Playback Index ScreenEN43 Protecting Images 44 ENTo Protect AN Image To Remove ProtectionEN45 Deleting ImagesTo Delete the Displayed Image To Delete ALL ImagesSuperimposing a Print Frame 46 ENTo Make The Print Frame Disappear Press Print FrameEN47 Initialising a Memory CardYou can initialise a memory card anytime Print Frame Deletion 48 ENTo Delete ALL Print Frames EN49Perform steps 1 through 5 on pag To Reset The Setting Setting Print Information Dpof SettingEN51 To Reset The No. Of PrintsTo Print by Selecting Still Images and NO. of Prints Perform steps 1 through 5 on pgTo TV or VCR 52 ENEN53 USB Mode Accessing File appears on Turn the camcorder’s Power Switch to While54 EN Connection To a Personal ComputerEN55 Connection To a Video Unit Equipped With a DV ConnectorMake sure all units are turned off Dubbing To a VCR 56 ENTo use this camcorder as a player Engage the VCR’s AUX and Record-Pause modesEN57 Dubbing From a VCRTo use this camcorder as a recorder VCR Playback deckDubbing 58 ENTo stop dubbing, press the Recording Start/Stop EN59Repeat steps 5 through 7 for additional editing Dubbing Images Recorded On a Tape To a Memory Card 60 ENEN61 Installing The BatteriesFunctions 62 ENButtons Feature Frame-By-Frame Playback Feature Slow-Motion PlaybackFeature Playback Zoom EN6364 EN Feature Playback Special EffectsSET REMOTE/VCR Code EN65VCR Recording deck 66 EN JVC VCR equipped with a remote pause connectorMake Connections VCR other than aboveSelect Scenes EN67Automatic Editing to VCR 68 ENEN69 For More Accurate EditingDiagnosing VCR/CAMCORDER Timing Recording deck70 EN Adjustment of VCR/CAMCORDER TimingAudio Dubbing Set 12BIT Mode to Sound 2 or MIX Menu Screen pgEN71 To hear the dubbed sound during playbackInsert Editing 72 ENCorrective Action Clean the lens and checkReplace with new cassette 74 EN EN75 Mode of Programme AERecording. The effects are Rapid panningDo not try to use the Classic 76 ENRemove protection from EN77 Camcorder When the LCD monitor’sDisplayed colours differ From those that are actually BlinkPress Memory Play to 78 ENLCD monitor LCD monitor’s Adjust the brightness Subject to extremely high 10C to 35C pg Low temperaturesEN79 Recommended to charge it Charger does not light80 EN Cleaning The CamcorderAfter Use Video Input/Output Connector DC Input Connector DC pgConnect the editing cable when performing Multi Connector82 EN RtyEEN83 These indications also appear during Dual mode Displays the Uxga mode Double orRotates while the tape is running VGA in order of qualityEN85 LCD Monitor/Viewfinder Indications During Video Playback Displays the sound modeLCD Monitor/Viewfinder Indications During D.S.C. Playback Displays the brightness of the LCD monitor or ViewfinderIndications Function EN87Possible Switch is set toSnapshot is pressed Appears, the memory card is corruptedTo avoid hazards EN89During use Store cassettes90 EN About moisture condensation EN91Serious malfunctioning 92 EN Time Code pg , 29, 39 EN93For General 94 ENFor Digital Video Camera For Digital Still CameraEN95 For ConnectorsGR-DV2000

Related manuals

Manual 96 pages 4.31 Kb