Remote sensor
ZOOM (T/W)
PLAY
STOP
Display
Interval time indicator
1M I N 
1 / 2S
Recording time indicator
Remote sensor
START/STOP
EN51
Playback Zoom
To magnify the recorded image up to 10X at any time during playback.
NOTES:
●Use the remote control unit to perform this procedure.
●Make sure that the TBC mode is activated ( pg. 23).
1)Press PLAY to find the scene of interest.
2)Press the ZOOM Buttons (T/W) on the remote control. Make sure the remote control is pointed at the camcorder’s remote sensor. Pressing T zooms in.
To End Zoom . . .
.... press and hold W until magnification returns to
normal. Or, press STOP and then press PLAY.
NOTES:
●Zoom can also be used during still playback.
●Due to digital image processing, the quality of the image may suffer.
●After zooming in on a still video image, when normal playback is started, the
Animation And Time-Lapse
The remote control lets you set/release Interval Time and Recording Time without using the Menu Screen.
Animation
1)Set
Instead of performing steps 1 and 2 on pg. 48
(“Animation”), press REC TIME on the remote control. Each time REC TIME is pressed, the Recording Time indicator appears, changing in the following order: 1/4S, 1/2S, 1S, 5S and no indication (off).
2)Release
Instead of using the Menu in step 5 on pg. 48
(“Animation”), press REC TIME on the remote control until the Recording Time indicator disappears.
Time-Lapse
1)Set
Instead of performing steps 1 and 2 on pg. 48 (“Time- Lapse”), press REC TIME and INT. TIME on the remote control. Each time REC TIME is pressed, the Recording Time indicator appears, changing in the following order: 1/4S, 1/2S, 1S, 5S and no indication (off). Each time INT. TIME is pressed, the Interval Time indicator appears, changing in the following order: 15S, 30S, 1MIN, 5MIN and no indication (off).
2)Release
Instead of using the Menu in step 4 on pg. 48 (“Time- Lapse”), press REC TIME and INT. TIME on the remote control until the indicators disappear.
NOTE:
REC TIME
INT. TIME
Also refer to pg. 48.