JVC GR-SXM930, GR-SXM730 specifications EN57, Never remove the power supply unit at this stage

	EN57
When “DSC” is selected (the DSC Lamp is lit):
SYMPTOM	POSSIBLE CAUSE(S)
SHOOTING
Although SNAPSHOT is pressed, a still	● When the number of remaining shots available reaches “0”
image is not stored in the built-in	(blinking), it becomes impossible to take your next shot.
memory.	Perform “Deleting Images” function to remove some still
	images already stored in memory ( pg. 33).
It is not possible to shoot in sucession.	● A still image is in the process of being stored in memory for
	approx. 2 seconds after SNAPSHOT is pressed. During that
	time, it is impossible to take another shot. When the still image
	disappears and the scene you are currently aimed at appears
	on the screen, take another shot ( pg. 28).
PLAYBACK
Although “ALL” is selected in the	● The “Protecting Images” function is in effect for some still
DELETE Menu Screen, all still images	images. If they are not necessary, cancel the “Protecting Images”
cannot be deleted.	function, then try deleting all still images again ( pg. 32).
OTHER
Date/Time Insert is not performed	● It is not possible to display the date/time on a still image.
while shooting a still image.
Instant Titles are not displayed while	● It is not possible to display the Instant Titles on a still image.
shooting a still image.
Some settings cannot be changed in the	● It is not possible to set “REC TIME” and “INT. TIME” in the
Menu Screen.	Menu Screen.

Since the camcorder is a microcomputer-controlled device, external noise and interference (from a TV, a radio, etc.) might prevent it from functioning properly. For example, when a still image you shot is stored in the camcorder’s built-in memory, the above may cause the following: Although the remaining number of shots indicator shows that shooting is possible, a still image cannot be stored in memory after shooting. In such a case, initialize the memory by following steps 1 through 3 below. Please note that initialization deletes all the still images (including ones for which you performed the “Protect” function) stored in the camcorder’s memory. If you wish to keep any of the still images that are stored in memory, before initialization first transfer them to a PC and save them. If image data is corrupt, transfer is impossible.

FORMAT

CANCE L

ENT ER

FORMAT Menu

1.Set the Power Switch to “ ”. If the DSC Lamp is not lit, press REFRESH for approx. 1 second to select “DSC”.

2.Press P.AE for more than 5 seconds. The FORMAT Menu appears.

3.Rotate the MENU Wheel to select “CANCEL” or “ENTER” , then press it.

•“CANCEL” does not initialize the memory.

•“ENTER” initializes the memory. During initialization, “ENTER” blinks. When initialization is complete, the screen becomes blue back.

CAUTION:

While “ENTER” is selected and it is blinking, switching off the camcorder or removing the power supply unit (battery pack or AC Adapter) may cause the camcorder’s built-in memory to become corrupt.

Never remove the power supply unit at this stage.