JVC GR-SXM930, GR-SXM730 specifications EN67, Vertically, in their original cases

Page 67

2. Store cassettes . . .

... away from heaters or other heat sources.

... out of direct sunlight.

... where they won’t be subject to unnecessary shock or vibration.

... where they won’t be exposed to strong magnetic fields (such as those generated by motors, transformers or magnets).

... vertically, in their original cases.

Main Unit

1. For safety, DO NOT . . .

.... open the camcorder’s chassis.

.... disassemble or modify the unit.

.... short-circuit the terminals of the battery pack. Keep it

away from metallic objects when not in use.

.... allow inflammables, water or metallic objects to

enter the unit.

.... remove the battery pack or disconnect the power

supply while the power is on.

.... leave the battery pack attached when the

camcorder is not in use.

2. Avoid using the unit . . .

.... in places subject to excessive humidity or dust.

.... in places subject to soot or steam such as near a

cooking stove.

.... in places subject to excessive shock or vibration.

.... near a television set.

.... near appliances generating strong magnetic or electric

fields (speakers, broadcasting antennas, etc.).

.... in places subject to extremely high (over 40°C or

104°F) or extremely low (under 0°C or 32°F) temperatures.

3. DO NOT leave the unit . . .

.... in places of over 50°C (122°F).

.... in places where humidity is extremely low (below

35%) or extremely high (above 80%).

.... in direct sunlight.

.... in a closed car in summer.

.... near a heater.

.... in dusty places such as a beach.

4.To protect the unit, DO NOT . . .

.... allow it to become wet.

.... drop the unit or strike it against hard objects.

.... subject it to shock or excessive vibration during transportation.

.... keep the lens directed at extremely bright objects for long periods.

.... direct the eyepiece of the viewfinder at the sun.

.... carry it by holding the viewfinder or the LCD monitor. Be sure to hold the main unit with both hands or use the grip.

.... swing it excessively when using the shoulder strap.

EN67

LCD Monitor

1.To prevent damage to the LCD monitor, DO NOT . . .

.... push it strongly or apply any shocks.

.... place the camcorder with the LCD monitor on the bottom.

2.To prolong service life . . .

.... avoid rubbing it with coarse cloth.

3.Be aware of the following phenomena for LCD monitor use. These are not malfunctions:

While using the camcorder, the surface around the LCD monitor and/or the back of the LCD monitor may heat up.

If you leave power on for a long time, the surface around the LCD monitor becomes hot.

How To Handle a CD-ROM

Take care not to soil or scratch the mirror surface (opposite to the printed surface). Do not write anything or put a sticker on either the front or back surface. If the CD-ROM gets dirty, gently wipe it with a soft cloth outward from the center hole using a circular motion.

Do not use conventional disc cleaners or cleaning spray.

Do not bend the CD-ROM or touch its mirror surface.

Do not store your CD-ROM in a dusty, hot or humid environment. Keep it away from direct sunlight.

About moisture condensation . . .

You may have observed that pouring a cold liquid into a glass will cause drops of water to form on the glass’ outer surface. This same phenomenon occurs on the head drum of a camcorder when it is moved from a cool place to a warm place, after heating a cold room, under extremely humid conditions or in a place directly subjected to the cool air from an air conditioner.

Moisture on the head drum can cause severe damage to the video tape, and can lead to internal damage to the camcorder itself.

Serious malfunctioning

If malfunctioning occurs, stop using the unit immediately and consult your local JVC dealer.

Image 67
Contents GR-SXM930 GR-SXM730 It is recommended that you Dear CustomerImportant Safety Instructions ImageFolio PC Connection Cable Battery PackPicture Navigator Presto Mr. Photo PhotoAlbumHow To Attach The Lens Cap Automatic Demonstration Getting Started ContentsSlide Battery Release and pull out the battery pack PowerCharging the Battery Pack To Detach The Battery PackApproximate recording time unit min Using the Battery PackUsing AC Power Perform of Charging the Battery Pack  pgShoulder Strap Attachment Grip AdjustmentViewfinder Adjustment 10 ENPress the Menu Wheel in to close the Menu Screen Date/Time SettingsAppears and then press it. The setting stops blinking EN1112 EN Recording Format SettingSqpb S-VHS Quasi Playback function EN13VHS VCR with Sqpb Function Regular VHS VCR14 EN Recording Mode SettingTape Length Setting Set the tape recording mode depending on your preferenceEN15 Loading/Unloading a CassetteOpen the LCD monitor fully Menu Screen Picture Mode Setting16 EN RETURN. Press the Menu Wheel in to closeVideo Recording & Playback ContentsRotate the Bright Wheel until the bright 18 ENVideo Recording To Stop RecordingJournalistic Shooting EN19SELF-RECORDING Zoom Slide the Power Zoom Lever towards TSlide the Power Zoom Lever towards W 20 ENSet Light OFF/AUTO/ON as required OFF Turns off the light EN21Video Playback 22 ENEN23 To cancel the effect, select OFF in stepUse optional Video and Audio cables 24 ENBasic Connections Use optional S-Video and Audio cablesTape Dubbing Power supply instead of the battery pack  pgEN25 Video Playback 26 ENDigital Still Camera C. Recording Playback Still Image Storage Mode Selection28 EN C. RecordingTo remove the still image you have checked Instant Delete EN29Slide Show 30 ENC. Playback Normal PlaybackIndex Playback Index ScreenEN31 To Remove Protection 32 ENProtecting Images To Protect AN ImageEN33 Deleting ImagesTo Delete ALL Images During transfer of the still image, the camcorder’s Close the software, then switch off the camcorder34 EN Connection To a Windows PCAdvanced Features Advanced FeaturesNight Auto Shutter speed is automatically adjusted maximum 1/6 sec36 EN Night-AliveFades in/out to a black screen Fade/Wipe EffectsEN37 FaderProgram AE With Special Effects 38 ENDigital Effects 40 EN Using Menus For Detailed AdjustmentPress the Menu Wheel in. The normal screen reappears System Menu EN41Menu Screen Explanations Camera MenuVHS 42 ENVHS ET Snapshot Recording Snapshot Mode SelectionSnapshot EN43Exposure Control 44 ENManual Focus FocusingEN45 Auto FocusTo Return To Automatic White Balance White Balance Adjustment46 EN Manual White Balance OperationInstant Titles Date/Time InsertEN47 Animation 48 ENTime-Lapse Functions Buttons Using the Remote Control Unit50 EN Installing The BatteriesAnimation And Time-Lapse Playback ZoomEN51 Insert Editing Video 52 ENTo insert still images in sequential order onto the tape TapeAudio Dubbing EN53References 54 ENTroubleshooting 56 EN EN57 Never remove the power supply unit at this stage58 EN Charging time varies according to the ambient temperatureIt may take a few seconds before TBC actually starts working TBC indicator turns green gray with a camcorder equipped# $ % 3 4 5 y u 8 9 60 ENEN61 Indications During Recording 62 ENTBC Indications During PlaybackEN63 64 EN ContentsDigital Still Camera Store a Still Image In The Built-In Memory EN65Tape Dubbing 66 EN Vertically, in their original cases EN6768 EN EN69 SpecificationsCarga DE LA Bateria 70 ENEspañol AlimentaciónUSO DE Alimentacion CON CA AtencionEN71 USO DE LA BateriaUtilización de la batería 72 ENPara extraer la batería Para extraer la batería Deslice Battery Release y extraiga la bateríaGuia Para Operacion Rapida D.S.C Utilización de la bateríaNew Maple Avenue Pine Brook, NJ 74 ENWarranty Only in U.S.A GR-SXM730