Panasonic AW-F575E manual System Connection, Connection with the VTR

SYSTEM CONNECTION

CAUTION: Keep the power switches of all units in the OFF position during connections.

A. ENG Application

1. Connection with the VTR

Connect the VTR cable between the camera and the Panasonic portable colour VTR (The standard VTR cable length is 3m. (10 ft).

Portable VTR wlth 14-pin camera connector VTR cable WV-CA26A/14 (26P-14P cable)

Portable VTR wth 26-pin camera connector VTR cable WV-CA26A/26 (26P-26P cable)

B. Gen-lock EFP Application	Notes:
	1	The Subcarrier	Phase Coarse a n d Subcarrier
		Phase Flne as well as the Horzontal Phase on the
1 Connect a coaxial cable for the gen-lock signal		camera should be set to match the other cameras
between the Gen-lock Input Connector (51) (BNC-		in the system Refer to page 49 for details
type) on the Camera Adaptor and the Black Burst	2. Refer lo the operatlng nstructlons accompanylng
		the Speclal Effects Generator for further detalls.
Output Conneclor on the production system, such as
	3	Do not connect	the coaxial cable for the gen-lock
the Special Effects Generator.
		signa1 to the Gen-lock Input Connectors (51) on
2 Connect the coaxlal cable for the vldeo output siIgnaI
		the Camera Head and on the Camera Adaptor
between the Monitor Output Connector (36) (BNC-		slmultaneously.

type) on the camera and the Video Input Connector on the production system.

2. Connection with the Remote Control Box

Connect the Remote Control Box Connector (37) on the Camera Head to the Remote Control Unit Extension Connector (156) on the Remote Control Box by using the optional RCB Cable WV-CA10B02, WV- CA10B25 or WV-CA10B50

Note: In the following system connection, the video signal from the Monitor Output Connector (36) on the Camera Head has priority of the video signal over the Monitor Output Connector (154) on the Remote Control Box, so the ptcture is not dis- played on the monitor connected to the Remote Control Box

The decrement of the video signal for the cable length is shown in the following table

The cable length	Decrement
2 m.	Approx.	10%
25 m.	Approx.	15%
50 m.	Approx.	20%
100 m.	Approx.	30%

- 40 -

3. Connection with a sub-VTR (back-up VTR)

Connect the sub-VTR’s camera connector to the Camera’s 10-pin Remote Control Box Connector

Notes:

1Only video slgnal, audio signal ( - 2 0 dB) a n d start/stop signal are sent to the sub-VTR

2.The extension cable length for the sub-VTR is up to 10m (30 ft).

3In the above system connectlon, the video signal from the Monitor Output Connec!or (36) on the Camera Head takes priority over the vldeo sIgnaI from the Monttor Output Conector (154) on the Remote Control Box

So, the picture is not displayed on the monitor connected to the Remote Control Box.

ENG Camera
		PREVIEW	PROGRAM
	BLACK BURST (GEN-LOCK)
ENG Camera	-
	; BLACK BURST (GEN-LOCK) -pp

BLACK BURST
VIDEO OUT	VIDEO	VIDEO INPUT

VIDEO OUT

- 41 -