Panasonic AW-F575E manual PC Mode System, Out

C. Studio Application

D. PC Mode System

Precaution: The specified software should be requlred for this operatlon. Please contact with qualifled service personnel for this operatlon.

PC Mode System 1

Connect the WV-CA10B02, WV-CA10625 or WV-CA10B50 10/10-pin cable between the Remote Control Box Connector (37) on this camera and Camera 1 Input Connector on the WJ-PC500

PC Mode System 2

Connect the WV-CA10B02, WV-CA10B25or WV-CA10B50 10/10-pin conversion cable between the Camera 1 Input Connector on this unit and the Remote Control Box Connector on the Remote Control Unit.

Connect the 25/9-pin converslon cable between the RS-232C/422 Connector on thls unlt and the computer

E. Gen-lock Studio Application

-Connect a coaxlal cable for the gen-lock signal between the black burst output on the productlon system and Gen-lock input

Connectors (143) or (203) on the RCU. (The signal may be bridged or looped through to another RCU.)

-Connect the coaxial cable for the lineview signal between the effect output connector on the production system and the Auxiliary Input Connector (144) or (204) on the RCU. (The signal may be bridged or looped through to another RCU )

Notes:

1.The Tally light and Intercom between the camera, RCU and Speclal Effects Generator will function only when the 4-pin cable for the Tally Iight and Intercom is connected between the RCU and Speclal Effects Generator.

2. The 26-pin studlo cable can be extended up to a maxlmum of approx 300m (1000 ft). When extending the cable, be sure to Set the Cable Length Compensation Switch (115) to the position matching the extension lenght

3.The Subcarrier Phase Coarse and Fine Controls (139) and the Horizontal Phase Control (138) or (198) on the RCU should be set to match other cameras in the system. Refer to page 54 for details. lo etalls.

4. Be sure to Set the Cable Selection Switches (73) on the Camera Adaptor and (152) or (201) on the Remote Control Unit to MULTI positlon, if using the 26-pin multicores studio cable

- The MPX mode is avaliable when connecting the Camera Adaptor AW-AD700BSE

G/L OUT

Notes:

1When using the MPX mode by connecting the AW-AD700BSE, INCOM. AUX and R/G/B outputs are not functoned

2.When the Colour Camera AW-F575E is connected to a desk-top type S-VHS VTR or directly to the video monitor for S-VHS format, the S-VHS cable (S-vldeo cable) is required.

- 43-