![](/images/new-backgrounds/1218357/21835725x1.webp)
5” ELECTRONIC VIEWFINDER WV-VF65B
211. Tally Light
215. Peaking On/Off Switch (PEAKING ON/OFF) |
LENS CONTROL KIT WV-LK35
This light only works when the camera is “sed in full system operation with the Remote Control Unit (RCU) and Special Effects Generator This light Indicates that recording is in progress
212. Contrast Control (CONTRAST)
Turn this control clockwise to increase the contrast of the picture in the viewfinder
213. Brightness Control (BRIGHT)
Turn this control clockwise to increase the brightness of the picture in the viewfinder
214. Tally ON/OFF Switch (TALLY ON/OFF)
This switch turns on/off the Tally Light (211) located on front of the viewfinder
Normally this switch should be set to the OFF position |
However, when shooting under low light conditions, |
setting this switch to the ON position will facilitate easi- |
er focusing adjustment |
216. Viewfinder Adjustment Knob |
The angle of the 5" viewfinder can be adjusted for easy and comfortable viewing
217.Tally Indicator
When used in full system operation with the Remote Control Unit (RCU) and Speclal Effects Generator. this indicator shows the camera operator that recording is in progress and the recording signal is being sent to the line output.
218.5” Viewfinder Mounting Bracket WV-071
This is used to mount the 5" Electronlc Viewfinder WV- VF65B, on the
See page 34 for installation details
221. Clamper
Install the zoom controller on the right tripod arm by using this clamper.
222. Servo Zoom Control
The 1.4f zoom lens can be controlled by pressing this Control to zoom in/out for tele/wide picture with motor drive. The zoom speed can be adjusted by changing the pressure on this control
223. Return Video Button
In a studio application using a special effects genera- tor, the lineview signal is displayed on the viewfinder while this button is being pressed. When a Panasonic
3/4"
224. VTR Start/Stop Button
This button is used to start or pause the VTR Press this button for recording and press it again for pause.
225. Clamper
Install the focus controller on the left tripod arm by using this clamper
226. Focus Controller
Turn this controller for adjusting the lens focus
inout
- 29 -