Chapter 3 Recording and playback
3-7 RETAKE function
The RETAKE function ensures continuity with the previous cut on the tape when shooting is resumed.
It is set by opening the <REC FUNCTION> screen from the SYSTEM SETTING page and selecting ON as the setting for the RETAKE MODE item by performing menu operations.
The RETAKE MODE item settings are described below.
ON: The retake operation is performed when the RET button on the lens is pressed while the MODE CHECK button is held down.
OFF: The RETAKE function does not operate.
If, when the
If there is some leeway in the shooting time and a “NG” condition has been clearly identified, recording can be started from this point, and the cut in the NG area will be deleted.
This function is particularly useful for cutting the amount of time taken for copying onto work tapes and other such economical operations.
Direction of tape travel
Cut 1 | Cut 2 | Cut 3 |
|
|
|
Approx. 10 frames
Cut 1 | Cut 2 |
| Cut 4 |
|
|
|
|
Cut 3
When the RETAKE function is to be exited
There are two ways to do this.
1)Set the unit’s POWER switch to OFF.
2)Perform a menu operation and select OFF as the RETAKE MODE item setting.
3-8 Rec-review function
When recording is temporarily stopped and the lens RET button is pressed, the last two seconds of the tape are automatically rewound, and the playback pictures on this part of the tape appear on the viewfinder screen. This makes it possible to check whether recording was performed properly.
After the two seconds of the tape have been played back, the unit is again set to the recording start standby mode.
If the RET button is held down, a maximum of 10 seconds of the tape is rewound and played back.
The RET button function can be allocated by opening the <USER SW> screen from the OPERATION page and selecting settings for the USER MAIN SW, USER1 SW and USER2 SW items by performing menu operations.
<Note>
≥The
≥If the OUTPUT SEL switch on the side panel is at the VTR position during the
Direction of tape travel
|
|
| |||
|
|
|
|
|
|
|
| Recording section |
| No recorded or already recorded section | |
|
|
|
|
|
|
|
| 2 to 10 sec. |
|
|
|
|
|
| |||
|
|
|
|
|
|
|
| Playback of recorded section |
|
|
|
|
|
|
|
|
|
3-9 Normal playback and playback at different speeds
≥In order to view these images, the OUTPUT SEL switch on the side panel must be set to the VTR position.
In addition, when the FF and REW buttons are used, the images can be played back at different speeds by establishing the cue mode (PLAY + FF), review mode (PLAY + REW),
26