Panasonic AJ- E operating instructions Option Mode

Item/

Variable

Remarks

Data storage

range

P.OFF GPS DATA

HOLD

For selecting whether or not to hold the UMID

CLEAR

GPS position information while the power is

off and record the information as the data still

held as the previous value until another

measurement can be taken after the power is

next turned on.

HOLD: The data is held and recorded.

CLEAR: The data is cleared at the same time

as the power is turned off, and all

zeros (no information) are recorded

from the time the power is turned on

C U F

until the measurement is next taken.

COMPONENT OUT

ON

For selecting whether to conserve the power

OFF

of the component output to peripheral units.

ON: Component signals are output to the

peripheral units.

OFF: Output stops during power save. (Note

that this setting is forced ON if a

camera adapter is connected and a

tally signal is detected from pin 26.

C U F

Otherwise it is OFF.)

1394 SPEED

S100

For setting the transfer speed of the signals to

S200

be output from the DVCPRO connector.

S400

S100: 100 Mbps

S200: 200 Mbps

C U F

S400: 400 Mbps

1394 IN CH

0

For setting the input channel for the signals to

:

be supplied to the DVCPRO connector.

63

0-63:

AUTO

The channel is fixed at the specified

number.

AUTO:

The channel corresponding to the setting of

C U F

the externally connected unit is selected.

1394 OUT CH

0

For setting the output channel for the signals

:

to be output from the DVCPRO connector

63

0-63:

AUTO

The channel is fixed at the specified

number.

AUTO:

The channel corresponding to the setting of

C U F

the externally connected unit is selected.

26PIN VIDEO

COMPONENT

For setting the video signals to be output from

SELECT

VIDEO OUT

pin #4 of the 26-pin connector when a 26-pin

camera adapter is connected.

COMPONENT:

The component Y signal is output.

VIDEO OUT:

The same signal (composite signal) as the

C U F

VIDEO OUT connector signal is output.

Item/

Variable

Remarks

Data storage

range

26PIN CONTROL

OFF

For setting whether recording is to be

BOTH

controlled by the unit or by both the unit and

the external VTR which is connected to the

26-pin camera adapter.

OFF:

Recording is performed by the unit only. (It

is not performed using the external VTR.)

BOTH:

Recording is performed by both the unit

and the external VTR. The tally lamp

indicates the status of the tally signal of the

26-pin connector. (The tally lamp setting

can be established using REC TALLY in

C U F

the SYSTEM MODE.)

26PIN CTL

NORMAL

For setting the control signal of the VTR to be

DEFAULT

SPECIAL

output from pin #12 of the 26-pin connector

when using a VTR connected to a 26-pin

camera adapter.

NORMAL:

STOP “low,” START “high” (for AJ-D92)

SPECIAL:

C U F

STOP “high,” START “low”