Panasonic AJ- E operating instructions Giving a title to the selected file

Chapter 4 Adjustments and settings for recording

Giving a title to the selected file

4 Turn the JOG dial button to move the arrow (cursor) to the “TITLE : ” item.

< CARD READ/WRITE >

R.SELECT :1

READ

W.SELECT :1

WRITE

CARD CONFIG

TITLE READ

#TITLE:

1:******** 5: ********

2:******** 6: ********

3:******** 7: ********

4:******** 8: ********

Saving the data settings to the selected file

9 When the title has been input, turn the JOG dial button to move the arrow (cursor) to the “:” position.

< CARD READ/WRITE >

R.SELECT	1
READ
W.SELECT	1
WRITE
CARD CONFIG	4
TITLE READ
;
TITLE:

1:******** 5: ********

2:******** 6: ********

3:******** 7: ********

4:******** 8: ********

5 When the JOG dial button is pressed, the arrow (cursor) moves to the title input area, and the input mode is established.

< CARD READ/WRITE >

R.SELECT :1

READ

W.SELECT :1

WRITE

CARD CONFIG

TITLE READ

;

TITLE:

1:******** 5: ********

2:******** 6: ********

3:******** 7: ********

4:******** 8: ********

10 When the JOG dial button is pressed, the arrow (cursor) returns to the TITLE: item.

11 Turn the JOG dial button to move the arrow (cursor) to the WRITE item.

12 When the JOG dial button is pressed, the following message appears.

6

7

8

Press the JOG dial button again and turn it until the character to be set is displayed.

When the button is turned, the character displayed is switched in the following sequence:

Space: ∑ 7

letters: A—Z 7

numbers: 0—9 7

symbols: ’, >, <, /, –

Press the JOG dial button to enter the character.

Turn the JOG dial button to move the arrow (cursor) to the next position (right), and repeat steps 6 and 7 to set the characters (maximum of 8).

WRITE?

YES

#NO TITLE:

If one of the following messages appears when the JOG dial button is pressed, the data cannot be saved.

Error message	Remedial action
WRITE NG NO CARD	Insert the card.
(setup card has not been inserted)
WRITE NG FORMAT ERROR	The card was formatted by a device
(formatting error)	other than the unit.
	Replace the card.
WRITE NG ERROR	The card may be defective.
(the data cannot be saved)	Replace it.
WRITE NG	Remove the card to cancel write
WRITE PROTECT	protect.

51