Panasonic BM-ET330 operating instructions Installation, Wall

■Installation

Cautions:

•Mount the iris reader to the flat and firm wall with the supplied mounting bracket. Besides, secure the iris reader and bracket with the supplied mounting screw, at the time of the mounting. Otherwise, it may cause dropping, trouble or injury.

•Check if the wall has enough strength for mounting and no dents. Otherwise, the rear tamper detection switch will not be pressed and the tamper detection mode will be activated.

The iris reader can be mounted over the wall as described.

1.Bury the anchor into the wall. (Refer to the illustration of "Dimensions of the Mounting Bracket".) The anchor bolt should meet the standards shown in the illustration.

	20 mm
	{0.79 in.}			192 mm {7.56 in.}
27 mm				150 mm {5.90 in.}
{1.06 in.}
	158.5 mm {6.24 in.} 144.3 mm {5.68 in.} 178.5 mm {7.03 in.}			in.}
201mm {7.91in.}				{4.29	41 mm
					{1.61 in.}
				mm	30 mm
		8 mm {0.31 in.}			{1.18 in.}
				109
			52.5 mm	{2.06 in.}
			73.5 mm		50 mm {1.97 in.}
	16 mm		{2.89 in.}
			83.7 mm {3.29 in.}
	{0.63 in.}

Projection of the tamperproof switch

Mounting hook (x4)

119 mm {4.68 in.}

6 mm {0.24 in.} or less

φ13 mm	φ11.5 mm
{0.51 in.}	{0.45 in.}
or less	or less
	Anchor bolt
	Washer

Mounting bracket

1 mm {0.04 in.} (D)

Notes:

Wall

Equivalent to anchor M6

Dimensions of the mounting bracket

2. Attach the iris reader to the mounting bracket.

	Mounting hook (x4)
Anchor bolt	Mounting
(1) Attach the supplied	bracket

mounting bracket to the wall, and then attach the iris reader to the mounting bracket.

Video cable and power cable (Refer to p. 18 for the

•Wall's capacity is 100 N or more.

•Anchor bolt's capacity is 100 N or more (per one).

•Take a side view to make sure that all the mounting hook holes of the iris reader have been hung over the mounting hooks of the mounting bracket. If the rear tamper detection switch is not be pressed, the iris read- er may not work properly.

Wall Wall

Tamper detection switch

specifications of these cables.)

(2) Hang the mounting hook holes of the iris reader over the mounting hooks of the mounting bracket.

(3) Fix the iris reader and mounting bracket with the supplied mounting screw.

(4) Connect the cables to the iris reader.

Note: If you lay cables along a wall surface, replace the cable hole cover on the bottom of the iris reader. (Refer to p. 13.)

20