Panasonic BM-ET330 Settings of this appliance are configured by the iris server

Page 9

The settings of this appliance are configured by the iris server.

The operational setting of this appliance is configured by the optional Administration Software BM-ES330E*, which is to be installed in the iris server.

Depending on the settings, the voice guidance will not be output or the live indicator will be off at all times. Refer to system administrators for details on settings.

*If the previous version of Administration Software (BM- ES300E or BM-ES300AE) is installed on the iris server, you cannot set up iris readers or distribute iris data from the iris server to iris readers.

Take care not to pinch your hands or fingers between the front panel and the body of this appliance. That may cause injury.

When the front panel is damaged, refer to the dealer. It may affect iris image capturing and cause invalid recognition.

Avoid placing a receptacle that contains liquid such as water.

When the liquid falls over the appliance, it may cause a fire or electric shock.

Follow all instructions. Otherwise, our liability will be limited.

IN NO EVENT SHALL MATSUSHITA ELECTRIC INDUS- TRIAL CO., LTD. BE LIABLE TO ANY PARTY, EXCEPT FOR REPLACEMENT OR REASONABLE MAINTE- NANCE OF THE PRODUCT, FOR ANY DAMAGES AND LOSSES, INCLUDING WITHOUT LIMITATION, DIRECT OR INDIRECT, SPECIAL, CONSEQUENTIAL OR EXEM- PLARY, ARISING OUT OF OR RELATING TO (A) USE OF THE SYSTEM AND/OR DEVICES OTHER THAN THE PRODUCT; (B) UNAUTHORIZED USE OF THE PROD- UCT; (C) UNAUTHORIZED REPAIR OR MODIFICATION OF THE PRODUCT.

For more details, refer to "LIMITATION OF LIABILITY" (p. 4).

9

Image 9
Contents Operating Instructions English Version Important Safety Instructions Trademarks and Registered Trademarks Limitation of LiabilityContents As a recognition iris reader for iris recognition PrefaceAccess control system can be composed FeaturesSupporting a common access control interface Built-in video surveillance cameraPrecautions General Safety RequirementTo avoid fire or personal injury Settings of this appliance are configured by the iris server Document Convention Notification about this Document Front View External ViewRear View Rear tamper detection switchInternal View Mounting hook holeConnection terminal Specifications of RS-485 Connectors for Card Reader Accept Specifications of Alarm Output ConnectorsDescription about the Connection Example Installation and ConnectionsPreparation Notification about the Installation SitePreparing the Necessary Items Cable PreparationInstallation Space and Recognition Range Keep the Installation SpaceCheck the Capturing Range Wall InstallationAttach the LAN cable to the LAN connector If you are wearing contact lenses Instructions for Proper Enrollment and RecognitionHow to Position Your Eyes in the Mirror Stand where you can see the iris reader from the front sideYes Make sure that you can see both eyes in the mirror Hold the tilt handles at the sides of the front panelCases of Enrollment/Recognition Failure If You are Wearing an Eyepatch, etcStand Sit down in front of the iris reader How to Carry out EnrollmentIf you are wearing glasses/sunglasses, take them off Start iris image capturingResult is output Recognition by an Iris Reader only How to Carry out RecognitionMove your face so as your eyes are positioned within 50 cm 64 ft. from the iris readerDuring capturing, open your eyes widely Recognition by an Iris Reader and a Card Reader Pass a card through the card readerVoice guidance Rejectaccept When Enrollment/Recognition Becomes Invalid TroubleshootingCases of Enrollment/Recognition Failure Before Requesting for RepairProblem Check item Remedy General SpecificationsInput/Output FunctionStandard Accessories Osaka, Japan