Panasonic WV-CW964 operating instructions DIP Switch Settings, Communication Parameters DIP Switch

DIP SWITCH SETTINGS

In a configuration, the camera's RS485 data port is used for camera control by the system controller, the camera's DIP switches must be configured to specify the unit number and communication parameters.

You need to set the DIP switches before installing the camera in the ceiling or on a wall.

1.Attaching and removing the Upper Base

Refer to the installation manual of the mounting brackets sold separately for installation for removing the Upper Base.

2.Remove the protective sticker from the top of the sun shield. (Keep the protective sticker for in step 4.) The DIP switches can be set now.

3.Set the DIP switches as the following: Communication parameters: Set with switch 2 Unit number: Set with switch 1

4.Put the protective sticker back over the DIP switches.

Camera top view

		S
		TA RT
	AC1	00V専用
WRS485Se
S		tting
1
		SW2

	O
	N
1
2
3
D	4
IP	5
	6
SW	7
1	8

N			4
O		3
		2	SW2
	1
		IP
		D

Protective Sticker

DIP Switch

■Communication Parameters (DIP Switch 2)

The factory default settings are all OFF.

ON

1 2 3 4

Communication

Parameters

Terminator

Switch 1: Terminator (Internal Termination Resistance)

Set to ON in the following situations.

•When only one camera is connected.

•When only one camera is connected via a daisy chain over a long distance.

Switches 2 to 4: Communication Parameters

This setting toggles between 2-line and 4-line communication. Use these switches to select the communication protocol being used.

	ON						ON
		1	2	3	4			1	2	3	4
4-line Communication						2-line Communication

-13-