CAMERA INSTALLATION
Precautions
•Make sure that the place you are installing the camera is strong enough to support it. If it is not strong enough, then the camera may fall and hurt someone.
•The following steps of installation and connection work should be done by qualified service personnel or system installers and should conform to all local codes.
•Be sure to turn the power off before installation and connection.
•Do not install the camera near the air outlet of an air conditioner.
■Mounting the Camera
Ceiling mount
The figure shows an example of the camera mounted on a ceiling with a locally procured bracket.
Refer to the instructions included with the bracket for filling gaps and holes with waterproof material.
Prepare appropriate hardware (e.g. wall nuts, anchor bolts, etc.) for fixing on the installation surface.
2.Disassembling the Camera
(1)Remove the upper base from the camera by loosening 3 screws. The screws that are removed need to be used during reassembly. Be careful to not lose them. Turn the upper base and separate it.
*Special screw (mounting screw): Use a hexagon wrench for the hexagon button screw (M6).
x3
●Construction
40
| (Ø 58) |
|
40 | (60) | 25 |
|
|
PT11 crest (parallel pipe thread) | 85 |
●Assemble procedure
1.Preparations
(1)Procure a ceiling mount bracket.
(2)To prevent the camera from falling, use a mounting a bracket to which a safety wire can be attached.
(3)Installation Surface
Caution: Consult an expert on the load bearing capacity of the installation surface and structure. If the surface is not strong enough, the camera may fall down. Refer to the product specifications for weights.
(2)Remove the attachment pipe from the upper base by loosening 4 screws.
*Special screw (mounting screw): Use a hexagon wrench for the hexagon button screw (M6).
x4