Caution :
Before closing the Cassette Holder 0, be sure your fingers have not been placed underneath the Cassette Holder as shown below. This may cause your fingers to jam in the cassette holder.
Do not place fingers here. | [Bottoln View] |
Only after the Cassette Holder is
completely housed, close the Cassette
Compartment Cover by pressing the mark
O.
e
00000
0
III When the Cassette Holder does not come out
•Close the Cassette Compartment Cover completely, and then open it again completely.
•Check if the battery has run down.
•Check if the Cassette Compartment Cover is in contact with grip belt as shown below, tf so, be sure the grip belt stays clear of the cover when opening.
III When the Cassette Holder cannot be housed
•Set the [OFF/ON] Switch to [OFF], then to [ON] again.
•Check if the battery has run down.
Notes:
•After use, be sure to rewind the cassette
completely, remove it and put it in a case. Store the case in an upright position. (p. 74)
•If the indicator of the condensation does not display on the LCD screen and/or Viewfinder and
you notice condensation on the lens or the main uniL do not open the cassette cover otherwise
condensation may be formed on the heads or the cassette tape. (p. 73)
•When inserting a previously recorded Cassette, use the Blank Search Function (p. 31) to find the position where you want to continue recording.
If you
•If a new Cassette is inserted, rewind to the beginning of the tape before starting recording.
•When inserting the cassette, make sure it faces in the right direction and then push it in until it stops.
•When the Cassette Holder is in action, do not touch anything except the [PUSH] mark.
•Close the Cassette Compartment Cover tightly.
•When closing the Cassette Compartment Cover, do not get anything, such as a cable, caught in the cover.
Opening the accidental erasure prevention slider
O on the cassette (by sliding it to the [SAVE] arrow direction) prevents recording. To enable recording, close the accidental erasure prevention slider (by sliding it to the [REC] arrow direction).
A Card can be used to record still pictures.
•Use a genuine SD Memory Card manufactured by Panasonic only.
Before inserting or removing a Card, be sure to turn off the Camcorder.
• Otherwise, the Camcorder may not function properly or it may cause the loss of recorded data in a Card.
1 Turn off the Power.
2Open the LCD Monitor and then open the Card Slot Cover.
W
5"
C
m
19