Press the Light Sutton | Panasonic PV-GS29, PV-GS39 guide

Press the [LIGHT] Sutton. O

,Gain Up mode is set to off.

,To eliminate washed out images, use this mode.

Press the [LIGHT] Sutton. _)

,The Video Light turns off.

,Pressing the [LIGHT] Button again returns to O.

Notes:

. The subject should be within 4.9 feet (1.5 meters) of the Camcorder.

,Using the LED Video Light reduces battery time.

,Set the LED Video Light to off when not in use.

,Do not look directly into the light.

,If the LED Video light is used with a Conversion

lens attached, a slight vignetting (darkening around edges) effect occurs on the screen.

,Using the MagicPix Function at the same time will make conditions even brighter.

,The LED video light enables simply lightening the images taken in a dimly-lit place. We also recommend using it in a bright place to obtain high quality images.

When Quick Start is ON the battery power is still being consumed, even when the LCD Monitor and the Viewfinder are closed.

The Camcorder will resume recording/pause mode about 1.7 seconds after the LCD Monitor and the Viewfinder are reopened.

,Please note in Quick Start Mode approximately

half the pause recording power is being consumed. Using Quick Start Mode will reduce the battery

recording/playback time.

,This function is only activated in the following cases:

-A tape or a card is inserted while the Tape Recording Mode is set.

-A card is inserted while the Card Recording Mode is set.

* Set to Tape/Card Recording Mode.

1 Set [ _ SETUP] >> [ _ QUICK START] >>

[ON].

While the [OFF/ON] Switch is still set to

[ON], close the LCD Monitor and retract the Viewfinder.

•The Green Lamp O lights up and the unit goes into Quick Start Standby mode.

3 Open the LCD Monitor or the Viewfinder.

•The Red Lamp lights up and the camera will be put into recording pause approx. 1.7 seconds after it is turned on.

I To Cancel the Quick Start

Set [ _ SETUP] >> [ 6it QUICK START] >> [OFF].

•If the standby continues for approx. 30 minutes, then the Lamp (Green) wilt go off and the Camcorder will be completely turned off.

Notes:

•When you set [ _z POWER SAVE] to [5 MINUTES] and the Camcorder is left in the Recording Pause Mode for 5 minutes, the unit will turn off. [Green LED will lit up.) Close the LCD Monitor and retract the Viewfinder. To turn the Camcorder on open the LCD Monitor and/or the Viewfinder.

•If the Mode Dial is moved or the battery is removed in Quick Start standby mode, Quick Start is canceled and the power turns off even if the [OFF/ ON] Switch is set to [OFF]. (However, changing the mode between Tape Recording Mode and Card Recording Mode will not cancel Quick Start.)

•When the Camcorder is Quick-Started with the White Balance on automatic, it may take some time until the White Balance is adjusted if the scene being recorded has a light source different from the scene last recorded. (When the MagicPix Function is used, however, the White Balance of the scene last recorded is retained.)

•If the power is turned on in Quick Start standby, the zoom magnification becomes 5× and the picture size may differ from what it was before Quick Start standby.

•When using the AC Adaptor, Quick Start can be used even if a tape is not inserted.