AutoDome Modular Camera SystemVG4 Firmware Updates via the CTFID en 17
2.4 | Launching the CTFID Software |
| You must install the CTFID software on the computer from which you will configure a camera. |
| To install the CTFID software, refer to the CTFID User’s Manual for instructions. |
| The method in which the CTFID software responds depends on the type of connection (Bilinx |
| or serial) it detects. The CTFID initially checks for a Bilinx connection through a USB port. If |
| the CTFID does not detect a Bilinx connection, the software prompts you to identify the type |
| of serial connection. |
2.4.1 | Launching with a Bilinx Connection |
| If using a Bilinx connection, use the following instructions to launch the CTFID software: |
| 1. |
checks for the Bilinx signal from the VG4 AutoDome. Once connected, the CTFID displays the Main Screen:
Figure 2.4 CTFID Main Screen
2.Proceed to Section 2.5 Uploading VG4 AutoDome Firmware Files, on page 20.
Bosch Security Systems, Inc. | Firmware Update Manual | F.01U.097.269 1.06 2011.09 |