Panasonic WV-CL920A operating instructions

Page 29

8.Adjust the horizontal phase by pressing or

. The adjustable range is 0 - 2.0µs.

9.Move the cursor to SC COARSE.

10.Press or to match the chroma phase of the camera’s video signal, when observed at the out- put of the Special Effect Generator (SEG) or Switcher, as closely as possible to the color of the original scene. (SC COARSE adjustment can be incremented in steps of 90 degrees (4 steps) by

pressing or .)

Note: After the fourth step, the adjustment returns to the first step.

1 (1 - - 4): 0 degrees

2 (1 - - 4): 90 degrees

3 (1 - - 4): 180 degrees

4 (1 - - 4): 270 degrees

11.Move the cursor to SC FINE.

12.Press or to match the color (hue) of the camera’s video signal, when observed at the out- put of the Special Effect Generator (SEG) or Switcher, as closely as possible to the color of the original scene.

-30-

The SC FINE adjustment has a range of 90 degrees of color shift.

Notes:

When the “I” cursor reaches the “+” end, it jumps back to “” . At the same time, SC COARSE is incremented by one step to enable

a continuous adjustment. The reverse takes place when the “I” cursor reaches the “” end.

When or is kept pressed for a second or more, the “I” cursor moves faster.

For more accurate adjustment, supply both the original camera video output signal and the effect output video signal (program output video signal) of the special effects generator (SEG) to a vectorscope and compare the chro- ma phase of both signals.

To reset SC COARSE and SC FINE to the val-

ues preset at the factory, press and simultaneously.

Image 29
Contents Operating Instructions Bol, within an equilateral triangle, is Contents Preface FeaturesClean the CCD faceplate with care PrecautionsDo not attempt to disassemble the camera Handle the camera with careWV-CL924 Major Operating Controls and Their FunctionsFlange-back Adjusting Ring FB Auto Iris Lens Connector0Gen-lock Termination Switch Hi-Z, G/L 75Ω 1Gen-lock Input Connector GEN-LOCK4AC/DC Compatible Input Terminal DC 12V IN/AC 24V 3Power Cord SocketWV-CL924 12 V DC/24 V AC ConnectionsWV-CL920 120 V AC 60Hz Recommended wire gauge sizes for 24 V AC line AC Power SupplyInstallation of Auto Iris Lens Connector Mounting the Lens Focus or FLANGE-BACK Adjustment Mounting from the top Installation of CameraCamera Setup Menu SetupATW1 ATW2 AWC Press and hold down for 2 seconds or more Opening the Setup MenuAll Reset Operation Setup OperationImportant Notice Editing the CAM SET UP MenuCamera Identification Camera ID Setting Setting ProceduresTo edit the Camera ID To enter a blank space in the Camera IDTo determine the display position of the Camera ID Light Control Setting ALC/ELCTo erase all characters in the editing area Back Light Compensation Back Light Comp ALC Mode with Preset onALC Mode with Preset OFF Blinking Gain Control Setting AGC ON/OFF Shutter Speed Setting ShutterElectronic Sensitivity Enhancement Sens UP Important Notices Synchronization Setting SyncVBS Gen-lock Mode Extvbs Page Line-lock Sync Mode LL VS Gen-lock Mode ExtvsPhase Coarse ATW1 Auto Tracing White Balance White Balance Setting White BALAuto-Tracing White Balance Mode ATW Select AWC → Manual Fine Adjustment for AWC ATWMotion Detector Setting Motion DET Lens Drive Lens Drive Signal SelectionSpecial Menu Special Burst BW Prevention of Blooming and Smear To reset to the factory settingsAGC SpecificationsPage Standard Accessories Optional Accessories Panasonic Canada Inc