Panasonic WV-CL920A operating instructions Special Menu Special

10. Special Menu (SPECIAL)

This menu lets you adjust and set up the video signal of the camera to meet your requirements.

Move the cursor to END on the bottom line of the CAM

SET UP menu and press and simultaneously

(hold down and press ) for 2 seconds or more. The SPECIAL menu appears on the monitor as shown below.

	** CAM SET UP **				** SPECIAL **
CAMERA ID			OFF	↵	UP SIDE DOWN	OFF
ALC/ELC			ALC	↵
SHUTTER			OFF		CHROMA GAIN	....I....
AGC			ON (DNR-H)		AP GAIN	....I....
SENS UP			OFF		PEDESTAL	.I
SYNC			INT		HUE	.I
WHITE BAL			ATW1↵			-	+
MOTION DET			OFF		BW	OFF
LENS DRIVE			DC		BURST (BW)	ON
					CAMERA RESET	PUSH SW
	END	SET UP ENABLE			RET END

10-2. Chroma Level Setting (CHROMA GAIN)

1.Move the cursor to the CHROMA GAIN parameter.

2.While observing the vectorscope or color video monitor, move the “I” cursor to adjust the chroma level.

10-3. Aperture Gain Setting (AP GAIN)

1.Move the cursor to the AP GAIN parameter.

2.While observing the waveform monitor or color video monitor, move the “I” cursor to adjust the aperture gain level.

10-4. Pedestal Level Setting (PEDESTAL)

1.Move the cursor to the PEDESTAL parameter.

2.While observing the waveform monitor or color video monitor, move the “I” cursor to adjust the pedestal level (black level).

10-1. Camera Picture Upside Down Positioning

(UP SIDE DOWN)

1.Move the cursor to the UP SIDE DOWN parameter.

2.Select ON when you want to turn the picture upside down.

10-5. Chroma Phase (Hue) Setting (HUE)

1.Move the cursor to the HUE parameter.

2.While observing the vectorscope or color video monitor, move the “I” cursor to adjust the hue (chroma phase) level.

10-6 BW

1.Move the cursor to the BW parameter.

2.Select AUTO1, AUTO2, ON or OFF using or

.

-37-