Axis Communications 2 user manual Factory Default Settings

38 The System Options AXIS 230

The Factory Default Settings

In certain circumstances, it may be necessary to reinstate the Factory Default settings for your AXIS 230. This is performed in one of two ways:

•By clicking the Restore button from the Maintenance page under System Options. This action will reset most of the unit’s parameters but will save the IP-address, the Subnet mask and the Default Router.

•By pressing the Reset button, located on the rear panel. This option will reset ALL the parameters currently configured in the unit, i.e. network settings, events, etc.

Follow the instructions below to reinstate the product factory default settings using the Reset button:

1.Switch off the AXIS 230 by disconnecting the power supply.

2.Press and hold the Reset button, and reconnect the power.

3.Keep the button pressed until the Status Indicator displays yellow (note that this may take up to 15 seconds), then release the button. When the Status Indicator displays green (which can take up to several minutes) the AXIS 230 will then have been reset to its original factory default settings.