System Tuning Input Gain Adjustment | Coustic D-block manual

SYSTEM TUNING (INPUT GAIN ADJUSTMENT)

Located on the Input Panel, the objective of GAIN adjustment is to match the output of the source unit with the input of the ampliﬁer. The output voltage of individual source units can vary. Some source units have an output of 200 mV and others have 5 Volts or more. To cater to these variations, the ampliﬁer has an adjustable gain control that ranges from 100 mV to 5 volts. Adjusting this control requires some experimenting to ensure all of the gain is at the beginning of the system, NOT at the end (ampliﬁer). Turn your source unit up and keep your ampliﬁer gains at the lowest possible setting (counter-clockwise) with the maximum output. This will give you the best sound and signal-to-noise ratio.

Besides better sonic reproduction, proper input gain also helps to prolong the reliability span of your ampliﬁer by eliminating excessive internal temperature generated by incompatible source unit output and ampliﬁer input.

Note : Turning the input gain up does not indicate more power. Just more noise. The input gain control is not a power control.

If the Remote Gain is used, connect the plug of the Remote Gain to the port on the panel of the ampliﬁer.

1.Turn the input GAIN all the way down (counter clockwise).

2.Set the volume control of the source unit to approximately 3/4 of its maximum output.

3.Turn the balance control of the source unit to its center position (ﬂat).

4.Leave the tone (bass/treble) controls at their usual position (ﬂat).

5.Play a CD or tape track with great dynamic range.

6.Use the Bass Boost Control on the amp to enhance the bass performance (if desired), not the bass on the headunit. Use this control sparingly.

7.To locate the optimum gain setting, ask the person assisting you to turn the input GAIN control clockwise until audio distortion starts to develop. Turn the gain control backwards slightly to minimize the distortion.

8.If you constantly switch between CD/tape and radio, you will need further adjustment since radio output level differs from that of CD or tape. In this case, you need to locate a balanced gain setting which is best for both the output level of radio and that of CD or tape