Coustic D-block manual Remote Gain Control, Connecting signal cables to the amplifier

Page 5

4. Remote Gain Control

Included is a remote gain control, which is a volume control that is active with the low pass filter engaged. This control should be mounted near the driver in an easily accessed location. This is not a gain knob, this is a level control. The level control will attenuate the amp or increase its output to the level of the gain setting. It is used to adjust bass output between music sources or tracks (see picture below for connection location).

5. Connecting signal cables to the amplifier

There are two ways to supply the signal to our amplifiers. To get maximum performance, we suggest connecting a high quality RCA to the corresponding outputs at the source unit and inputs of the amplifier. If a source unit is being used without RCA outputs, use the high-level inputs for signal which will turn the amplifier on via our Intelli-Sense™ circuitry (Four-channel amps will only engage on the front high-level inputs).

6. Reconnect the battery ground to the vehicle battery

Double check all the previous installation steps. Make certain the wiring and component connections are securely attached to the amp +BATT, remote and ground. If everything is in order, complete the installation by reconnecting the battery ground to the vehicle battery.

4

Image 5
Contents Page Introduction Specifications FeaturesConnect the amplifier to the battery InstallationConnect the amplifier remote turn-on Connect the amplifier ground to the vehicle chassisRemote Gain Control Connecting signal cables to the amplifierReconnect the battery ground to the vehicle battery Wiring Diagram Charging System Wiring Diagram 5.1 Surround Sound Example Wiring Diagram Single 4-CHANNEL Amplifier System Wiring Diagram Multi Amplifier System System Tuning Input Gain Adjustment Crossover Frequency Selection Freq System Tuning Crossover AdjustmentBass Boost Control Bass Boost Subsonic Filter SUB SonicTrouble Shooting Limited Warranty Conecte el amplificador a la batería CaracterísticasInstalación Nota Conecte el encendido a control remoto al amplificadorControl remoto de amplificación Conexión de los cables de señal al amplificadorSintonización DEL Sistema Ajuste DE Amplificación DE Entrada Selección de la frecuencia de crossover Freq Sintonización DEL SistemaControl de refuerzo de bajos Bass Boost Filtro subsónico SUB SonicResolucion DE Problemas Sonido bajo de la radio y el CD Branchez l’amplificateur sur la batterie CaractéristiquesBranchez les câbles de signaux sur l’amplificateur Branchez la mise en marche à distance de l’amplificateurRégulation de gain à distance Réglage DU Système Réglage DU Gain D’ENTRÉE Sélection de fréquence de filtre passif Freq Réglage DU Système Réglage DE Filtre PassifRéglage des Bass Boost Bass Boost Filtre subsonique SUB SonicRecherche DES Causes DE Pannes Page Schließen Sie den Verstärker an die Batterie an FeauturesFernbedienungs-Verstärkungsregler Schließen Sie das Signalkabel an den Verstärker anSchließen Sie den Verstärker an die Fernbedienung an Systemeinstellung Anpassung DES Eingangsvertsärkungsreglers Auswahl der Crossover-Frequenz Freq Systemeinstellung CROSSOVER-ANPASSUNGBass-Boost-Regler Bass Boost Subsonic-Filter SUB SonicProblemlösungen