Soundstream Technologies CA 160 installation instructions Door Locks, Diagram

Page 15

4. DOOR LOCKS

Negative Lock Output / Positive Unlock Output (GREEN)

Negative Unlock Output / Positive Lock Output (BLUE)

Negative Second Door Unlock Output (BLUE/GREEN)

The door lock / unlock outputs are designed to control several different types of systems which may require additional parts. Please review the wire and location chart to see which type of door lock system is in your vehicle. The most common types are shown in the diagrams below.

Negative Switching and Negative Switching with 2-step unlock feature:

All Door Lock and Unlock: Locate the lock / unlock wire at the vehicle’s lock / unlock switch.

Verification: These wires will register ground when the Lock and Unlock switches are activated.

Driver’s Door Unlock: Locate the unlock motor wire directly from the actuator inside the driver’s door.

Verification: This wire will rest at ground and register positive voltage when the driver’s door is unlocked.

Connect the GREEN and BLUE or BLUE/GREEN wires shown in diagram 6 below.

Note: When adding the 2 step unlock feature the BLUE/GREEN 2nd door unlock wire will be used to unlock all vehicle doors on the second press of unlock. An additional SPDT relay (not supplied) (Code Alarm part HDRLY) is required. Connect the relay as shown in diagram 7 to unlock the driver’s door on the first press of unlock.

Diagram 6

Door Lock Switch

GREEN (-) Lock Output

Lock

Vehicle Door Lock

Control Relays

Unlock

BLUE (-) Unlock Output Or BLUE/GREEN (-) 2nd Door Unlock Output when Installing The 2-Step Unlock

 

 

Diagram 7

Fused +12 Volt

 

 

Battery Source

87

 

 

 

 

87a

BLUE (-) Unlock Output

 

86

85

 

30

 

From Keyless Entry

 

To Unlock Side Of

Module Or Door

X

Driver's Door Actuator

Lock/Unlock Relays

CUT

 

 

 

Image 15
Contents For Authorized Dealers 800 CA 160 Installation InstructionsCA-160 System Layout CA- 160 System Layout Pin Power Harness RF Programmer Manual Feature ProgrammingUsing the M1 function Selecting Programmable FeaturesCA 160 Programming Guide Shock Sensor Programming 5 Chirps Setup & ProgrammingTransmitter Programming 3 Chirps RF Programmer Receive 4 ChirpsPIN Main Power Harness Battery Power REDVolts Ignition Input/Output Pink Positive Door Input Purple Basic Installation 22 PIN Base HarnessDome Light Supervision Output +/- BLACK/WHITE Negative Door Input GreenHood Pin Input Gray Ground When Armed Output OrangePIN Base Harness Headlight Output LT. GREEN/ORANGEInstant Trigger Input BLUE/WHITE Siren Output + BrownParking Light Output +/- White Manual ARM input LT. BLUE/RED Unlock Switch Sense LT. BLUE/GREENSong Bird Output BROWN/WHITE SB1 Accessory required Trunk Pin Switch Input BlueChannel 4 PINK/BLUE PIN Advance Channel HarnessChannel 2 PINK/BLACK Channel 3 PINK/GREENDoor Locks DiagramFused +12 Volt Battery Source Door Lock Switch Diagram Fused +12 Volt Battery Source Green Lock Output Door Lock Switch Adding Aftermarket Actuators System POWER-UP Procedure Accessory ConnectorsIf door, sensor, hood/trunk or ignition input is triggered Pre-arm modeSecurity Operation Press Lock once If the above conditions are not presentPress and hold Panic for 2 seconds Press DisarmPress Disarm twice Press Find