7. System Testing Cont.
Press DISARM:
1.Doors unlock.
2.Factory alarm (if equipped) is turned off.
3.Siren/horn sounds once/ parking lights flash once.
4.Courtesy lights turn on for 30 seconds, or until ARM is pressed or ignition is turned on.
5.Vehicle starter is enabled.
.
Press DISARM twice:
1.Passenger doors unlock if using
Press FIND:
Siren/horn sounds 5 times.
Press and hold PANIC for 2 seconds:
Siren/horn sounds and lights flash for 30 seconds or until any remote control button is pressed.
Press and hold TRUNK:
Trunk or hatch opens, or other device activates.
If Ignition Lock option is set to On:
Doors lock when all doors are closed and key is turned to ON position.
If Ignition Unlock option is set to On: Doors unlock when ignition is turned off.
8.Mounting the Module / Finishing the Installation
1.Mount the module to a brace or wire harness under the dash. The module and harnesses must be clear of moving parts.
2.Completely uncoil the antenna and route up the nearest front window pillar to the headliner. Be careful not to pinch the antenna under vehicle panels, or route near moving parts.
3.Route the antenna across the headliner to a position behind the rearview mirror.
4.Attach the antenna to the inside of the windshield behind the rearview mirror:
•The glass surface must be clean before mounting antenna. Use rubbing alcohol to thoroughly clean the mounting location.
•Remove protective backing and press firmly against windshield.
5.Plug antenna into the Reciever Plug located in the back of module (Black Connector).
Installation Complete