Soundstream Technologies CA 160 RF Programmer, Manual Feature Programming

Page 5

Programming Options

RF Programmer

The RF Programmer allows you to customize the system to fit the individual needs of the consumer, using a handheld device capable of transmitting system settings directly to the system control module. The RF Programmer is broken down into three different programming banks.

1.RF Programmer Bank- The RF Programmer Bank allows you to set up the base features of the system you are installing. It is very important to understand that the base features of this system can only be programmed using the RF Programmer. Please refer to the chart below showing factory default settings to determine what options need to be changed for your system. When using the RF Programmer to select feature settings is very important to verify that the correct base features remain at the default settings.

CA-160 RF Programmer Base Features

Feature

Default

Setting

 

 

 

Security

ON

 

 

Remote Start

OFF

 

 

1 Way/2 Way TX

2 Way TX

 

 

2.Feature Bank 1- Feature Bank 1 allows you to turn On/Off customer convenience features.

3.Feature Bank 2- Feature Bank 2 allows you to turn On/Off remote start features.

Manual Feature Programming

After installation is complete it will be necessary to program certain system characteristics that can't be programmed using the RF Programmer (Shock Sensor settings). In addition all of the customer convenience features and remote start features.

Image 5
Contents For Authorized Dealers 800 CA 160 Installation InstructionsCA-160 System Layout CA- 160 System Layout Pin Power Harness RF Programmer Manual Feature ProgrammingUsing the M1 function Selecting Programmable FeaturesCA 160 Programming Guide Transmitter Programming 3 Chirps Setup & ProgrammingRF Programmer Receive 4 Chirps Shock Sensor Programming 5 ChirpsVolts Ignition Input/Output Pink PIN Main Power HarnessBattery Power RED Dome Light Supervision Output +/- BLACK/WHITE Basic Installation 22 PIN Base HarnessNegative Door Input Green Positive Door Input PurplePIN Base Harness Ground When Armed Output OrangeHeadlight Output LT. GREEN/ORANGE Hood Pin Input GrayParking Light Output +/- White Instant Trigger Input BLUE/WHITESiren Output + Brown Song Bird Output BROWN/WHITE SB1 Accessory required Unlock Switch Sense LT. BLUE/GREENTrunk Pin Switch Input Blue Manual ARM input LT. BLUE/REDChannel 2 PINK/BLACK PIN Advance Channel HarnessChannel 3 PINK/GREEN Channel 4 PINK/BLUEDoor Locks DiagramFused +12 Volt Battery Source Door Lock Switch Diagram Fused +12 Volt Battery Source Green Lock Output Door Lock Switch Adding Aftermarket Actuators System POWER-UP Procedure Accessory ConnectorsSecurity Operation Press Lock once Pre-arm modeIf the above conditions are not present If door, sensor, hood/trunk or ignition input is triggeredPress Disarm twice Press DisarmPress Find Press and hold Panic for 2 seconds