4. DOOR LOCKS
Negative Lock Output / Positive Unlock Output (GREEN)
Negative Unlock Output / Positive Lock Output (BLUE)
Negative Second Door Unlock Output (BLUE/GREEN)
Positive Switching and Positive Switching with
All Door Lock and Unlock: Locate the lock / unlock wire at the vehicle’s lock / unlock switch.
Verification: These wires will register positive voltage when the Lock and Unlock switches are activated.
Driver’s Door Unlock: Locate the unlock motor wire directly from the actuator inside the driver’s door.
Verification: This wire will rest at ground and register positive voltage when the driver’s door is unlocked.
Connect the GREEN and BLUE or BLUE/GREEN wires shown in diagram 8 below.
Note: When adding the 2 step unlock feature the BLUE/GREEN 2nd door unlock wire will be used to unlock all vehicle doors on the second press of unlock. Two additional SPDT relays (not supplied) (Code Alarm part HDRLY) are required. Connect the relays as shown in diagram 9 to unlock the driver’s door on the first press of unlock.
Diagram 9
| Fused +12 Volt |
|
| |
| Battery Source |
|
| |
Door Lock Switch |
| 87 |
|
|
|
|
| BLUE/GREENBLUE/RED Second | |
|
| 87a |
| |
BLUE (+) Lock Output | 85 | Door Unlock Trigger | ||
|
| 86 | From Control Module | |
|
| 30 |
|
|
Lock | Vehicle Door Lock |
|
| |
|
|
| ||
|
| Control Relays |
|
|
Unlock |
|
|
|
|
Fused +12 Volt |
|
|
|
|
Battery Source | 87 |
|
|
|
|
|
|
| |
Chassis Ground | 87a | GREEN (+) Unlock Output |
| |
86 | 85 |
|
| |
|
|
| ||
| 30 |
|
| |
From Keyless Entry |
| To Unlock Side Of |
|
|
Module Or Door | X |
|
| |
Driver's Door Actuator |
|
| ||
Lock/Unlock Relays | CUT |
|
| |
|
|
|
| |